Search results
Results From The WOW.Com Content Network
The Brinell hardness is designated by the most commonly used test standards (ASTM E10-14 [2] and ISO 6506–1:2005) as HBW (H from hardness, B from brinell and W from the material of the indenter, tungsten (wolfram) carbide). In former standards HB or HBS were used to refer to measurements made with steel indenters.
A variety of hardness-testing methods are available, including the Vickers, Brinell, Rockwell, Meyer and Leeb tests. Although it is impossible in many cases to give an exact conversion, it is possible to give an approximate material-specific comparison table for steels .
Download as PDF; Printable version; In other projects ... Brinell hardness (MPa) [1] Brinell hardness (MPa) [note 1] [2] 3: Li: ... Vickers hardness test; Brinell ...
In this test a 10-millimetre diameter hardened steel or carbide ball is pushed into the surface of the material being tested, with a 3000 kg imposed load. The depth to which the ball penetrates the material surface is an indication of the Brinell Hardness Number, which is calculated as follows:
Scratch hardness. The Mohs scale of mineral hardness; The Vickers hardness test; The Brinell scale; The Janka hardness test; The Rockwell scale; The Durometer scale; The Barcol scale; The Leeb rebound hardness scale; The Rosiwal scale; The Meyer hardness test; The Knoop hardness test
The basic test requires applying the force in a consistent manner, without shock, and measuring the hardness (depth of the indentation). If a timed hardness is desired, force is applied for the required time and then read. The material under test should be a minimum of 6 mm (0.25 inches) thick. [3]
Additionally, the pages linked to the standards are wrong. I tried following the standard EN ISO 6506-1:2005: Metallic materials – Brinell hardness test – Part 1: test method and it was linked to a Vickers (NOT Brinell) standard (also withdrawn) — Preceding unsigned comment added by 79.136.68.68 10:56, 24 January 2019 (UTC)
Brinelling / ˈ b r ɪ n ə l ɪ ŋ / is the permanent indentation of a hard surface. It is named after the Brinell scale of hardness, in which a small ball is pushed against a hard surface at a preset level of force, and the depth and diameter of the mark indicates the Brinell hardness of the surface.