Search results
Results From The WOW.Com Content Network
The ICOM IC-7300 is a multimode 6 meter, 4 meter (ITU Region 1 only) and HF base station amateur radio transceiver. [1] The IC-7300 was announced to the public at the Japan Ham Fair in 2015. [ 2 ] The radio has 100 watts output on CW , SSB , and FM modulations and 25 watts of output in AM . [ 3 ]
The Icom IC-718 TS-2000X, same as the above with the addition 1.2 GHz capability; TS-B2000, a sleek "black box" unit requiring a computer or an optional mobile control panel for control; TS-2000LE, limited production TS-2000 with a black finish to celebrate Kenwood's 60th Anniversary
Software-defined radio (SDR) is a radio communication system where components that conventionally have been implemented in analog hardware (e.g. mixers, filters, amplifiers, modulators/demodulators, detectors, etc.) are instead implemented by means of software on a computer or embedded system. [1]
The highest DC power efficiency occurs when the time delta between PA Enable and the RF signal is minimized, but a short delay can exacerbate transient effects on the RF signal. Because the power-up/power-down operation of the PA can cause transient and thermal effects that degrade transmitter performance, another metric called Dynamic EVM is ...
Graphs illustrating the problem of image response in a superheterodyne. The horizontal axes are frequency and the vertical axes are voltage. Without an adequate RF filter, any radio signal S2 (green) from the antenna at the image frequency is also heterodyned to the IF frequency along with the desired radio signal S1 (blue) at , so they both pass through the IF filter (red).
The SINCGARS operates on any of 2320 channels between 30 and 88 megahertz (MHz) with a channel separation of 25 kilohertz (kHz). It accepts either digital or analog inputs and superimposes the signal onto a radio frequency (RF) carrier wave. In FH mode, the input changes frequency about 100 times per second over portions of the tactical VHF-FM ...
The near–far problem or hearability problem is the effect of a strong signal from a near signal source in making it hard for a receiver to hear a weaker signal from a further source due to adjacent-channel interference, co-channel interference, distortion, capture effect, dynamic range limitation, or the like.
The problem is similar to being at a rock concert and not being able to hear the weak signal of a conversation over the much stronger signal of the band. In general, isolating the receiver from the transmitter is made easier by maximizing, as much as possible, the separation between input and output frequencies.