Search results
Results From The WOW.Com Content Network
Antenna directivity is the ratio of maximum radiation intensity (power per unit surface) radiated by the antenna in the maximum direction divided by the intensity radiated by a hypothetical isotropic antenna radiating the same total power as that antenna. For example, a hypothetical antenna which had a radiated pattern of a hemisphere (1/2 ...
The frequency range or bandwidth over which an antenna functions well can be very wide (as in a log-periodic antenna) or narrow (as in a small loop antenna); outside this range the antenna impedance becomes a poor match to the transmission line and transmitter (or receiver).
Most antenna designs are not defined by a physical area but consist of wires or thin rods; then the effective aperture bears no clear relation to the size or area of the antenna. An alternate measure of antenna response that has a greater relationship to the physical length of such antennas is effective length l eff {\displaystyle l_{\text{eff ...
Phase-comparison monopulse is a technique used in radio frequency (RF) applications such as radar and direction finding to accurately estimate the direction of arrival of a signal from the phase difference of the signal measured on two (or more) separated antennas [1] or more typically
A discone is exceptionally wideband, offering a frequency range ratio of up to approximately 10:1 , over three octaves above the antenna's lowest frequency, but otherwise only functions just as well as other quarter-wave monopoles: It is omnidirectional, vertically polarized, equally efficient as a monopole, and has gain similar to a ground ...
The AoA can be calculated by measuring the time difference of arrival (TDOA) between individual elements of the array. Generally this TDOA measurement is made by measuring the difference in received phase at each element in the antenna array. This can be thought of as beamforming in reverse. In beamforming, the signal from each element is ...
Typical feeder loops are 1 / 8 to 1 / 5 the size of the antenna's main loop, which gives transform ratios of 64:1 to 25:1, respectively. Adjusting the proximity and angle of the feeder loop to the main loop, and distorting the feeder's shape, both make small-to-moderate changes to the transform ratio, and allows for fine ...
The discone antenna has a useful frequency range of at least 10 to 1. [2] [3] When employed as a transmitting antenna, a properly constructed discone is just as efficient as an antenna designed for a more limited frequency range. The extra bandwidth comes from the controlled taper and large termination radius of the cone.