Ads
related to: how does a motorcycle clutch work
Search results
Results From The WOW.Com Content Network
The main purpose of a slipper clutch is to prevent over engine rev and rear wheel hop (or clatter) especially under hard braking in a vehicle (usually performance motorcycles). It does so by partially slipping until the engine's speed matches with the vehicle's speed upon sudden braking. [1] [2]
Friction disk for a dry clutch. A clutch is a mechanical device that allows an output shaft to be disconnected from a rotating input shaft. [1] The clutch's input shaft is typically attached to a motor, while the clutch's output shaft is connected to the mechanism that does the work.
The clutch in a manual-shift motorcycle transmission is typically an arrangement of plates stacked in alternating fashion, one geared on the inside to the engine and the next geared on the outside to the transmission input shaft. Whether wet (rotating in engine oil) or dry, the plates are squeezed together by springs, causing friction build up ...
The suicide-clutch moniker has derived from difficulties in operating this form of clutch and shifter. On a motorcycle equipped with a conventional hand clutch and foot shifter, the rider places the left foot on the ground when stopped and holds the motorcycle in place with pressure on the rear brake pedal with the right foot, while engaging ...
One-way bearing combining sprags and bearing rollers in one race Sprags jam when driven and slide when in reverse. A sprag clutch is a one-way freewheel clutch.It resembles a roller bearing but, instead of cylindrical rollers, non-revolving asymmetric figure-eight shaped sprags, or other elements allowing single direction rotation, are used.
Once the engine has turned over and is running, the overrun clutch releases the starter from the flywheel and prevents the gears from re-meshing (as in an accidental turning of the ignition key) while the engine is running. A freewheel clutch is now used in many motorcycles with an electric starter motor. It is used on many combustion-engined ...
Clutch control is the controlling of the speed of a manual transmission vehicle by partially engaging the clutch plate, using the clutch pedal instead of (or in conjunction with) the accelerator pedal. The purpose of a clutch is in part to allow such control; in particular, a clutch provides transfer of torque between shafts spinning at ...
An early example of a semi-automatic motorcycle transmission was the use of an automatic centrifugal clutch in the early 1960s by the Czechoslovakian manufacturer Jawa Moto. [83] Their design was used without permission in the 1965 Honda Cub 50 , which resulted in Jawa suing Honda for patent infringement and Honda agreeing to pay royalties for ...