Ads
related to: cleaning water softener brine tank full of water
Search results
Results From The WOW.Com Content Network
Brine draw: Water is directed through a jet pump, which pulls salt water from the brine tank, before the water and brine pass through the resin bed in the normal direction, if co-current, or in the reverse direction, if counter-current. [12] The output of this typically thirty-minute process is discarded through the drain hose.
Chloride cycle dealkalizers operate similar to sodium cycle cation water softeners. Like water softeners, dealkalizers contain ion-exchange resins that are regenerated with a concentrated salt solution - NaCl. In the case of a water softener, the cation exchange resin is exchanging sodium (the Na + ion of NaCl) for hardness minerals such as ...
Brine (or briny water) is a high-concentration solution of salt (typically sodium chloride or calcium chloride) in water.In diverse contexts, brine may refer to the salt solutions ranging from about 3.5% (a typical concentration of seawater, on the lower end of that of solutions used for brining foods) up to about 26% (a typical saturated solution, depending on temperature).
In each stage, as the brine enters, its temperature is above the boiling point at the pressure of the stage, and a small fraction of the brine water boils ("flashes") to steam thereby reducing the temperature until an equilibrium is reached. The resulting steam is a little hotter than the feed water in the heat exchanger. The steam cools and ...
Spent backwash water is either discharged without treatment to a sanitary sewer system or is treated and recycled within the plant. [4]: 22.37–22.40 Historically, backwash water was discharged directly to surface water supplies; however, direct discharge is now highly regulated through NPDES discharge permits and is often discouraged. Used ...
Lime softening (also known as lime buttering, lime-soda treatment, or Clark's process) [1] is a type of water treatment used for water softening, which uses the addition of limewater (calcium hydroxide) to remove hardness (deposits of calcium and magnesium salts) by precipitation.