When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Example (inch, coarse): For size 7 ⁄ 16 (this is the diameter of the intended screw in fraction form)-14 (this is the number of threads per inch; 14 is considered coarse), 0.437 in × 0.85 = 0.371 in. Therefore, a size 7 ⁄ 16 screw (7 ⁄ 16 ≈ 0.437) with 14 threads per inch (coarse) needs a tap drill with a diameter of about 0.371 inches.

3. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   Not 0.1-inch pitch. Used by many radio ... A majority of JST through-hole headers can't withstand the temperatures required for reflow soldering, because the plastic ...

4. 19-inch rack - Wikipedia

   en.wikipedia.org/wiki/19-inch_rack

   The size denotes the width of the faceplate for the installed equipment. The rack unit is a measure of vertical spacing and is common to both the 19 and 23-inch racks. Hole spacing is either on 1-inch (25 mm) centers (Western Electric standard), or the same as for 19-inch (482.6 mm) racks (0.625 in or 15.9 mm spacing).

5. Treenail - Wikipedia

   en.wikipedia.org/wiki/Treenail

   The mortise is drilled 1 ⁄ 16 inch (1.6 mm) smaller than the treenail to create a tight fit and take advantage of friction in the mortise. In cases where the treenail is 24 inches (61 cm) or longer, the treenail should be shaped 1 ⁄ 8 inch (3.2 mm) smaller than the other half. In the same case the mortise is drilled in two parts, with a ...

6. AC power plugs and sockets: British and related types

   en.wikipedia.org/wiki/AC_power_plugs_and_sockets:...

   This was superseded in 1930 by BS 372 Side-Entry Wall Plugs and Sockets for Domestic Purposes Part II which states that there are only minor alterations from BS 317. In 1934, BS 372 Part II was in turn superseded by the first edition of BS 546 Two-Pole and Earthing-Pin Plugs and Socket Outlets. BS 546:1934 clause 2 specifies interchangeability ...

7. Resin identification code - Wikipedia

   en.wikipedia.org/wiki/Resin_identification_code

   Resin code for polyethylene terephthalate Polypropylene lid of a Tic Tac box, with a living hinge and the resin identification code, 5, under its flap. The Resin Identification Code (RIC) is a technical standard with a set of symbols appearing on plastic products that identify the plastic resin out of which the product is made. [1]