Search results
Results From The WOW.Com Content Network
Purchase replacement parts. You may purchase replacement parts for this machine by contacting a local Brother Authorized Service Center. You may use our ASC locator on our website at: Brother Authorized Service Center Locator. You can also purchase any external parts directly from Brother by contacting our parts department at 1-877-552-6255.
Follow the below steps to search by Model Name: 1. Click here to access the Brother Solutions Center. 2. ClickManuals. 3.Type your model number in theSearch by Model Name box and clickSearch. - Open a Manual by clicking onDownload. Follow the below steps to Search by Category:1.
Machine settings - PE535 machine parts. Applies to: PE535 - Machine Parts. A key that identifies some of the embroidery machine settings. Please refer to your embroidery manual for additional information. (13) Handwheel - Turn the handwheel toward you (counterclockwise) to raise and lower the needle to embroider one stitch.
Follow the steps below to install the update: 1. Check the software version of your machine first. a. Press the power switch to turn on your machine, then touch the screen. b. Press at the bottom of the display. The sewing settings screen appears. c. Switch screens by using or to display the software version.
Too much or too little tension will weaken the seams or cause puckers on the fabric. 1. When the bobbin thread is visible from the right side of the fabric, the upper tension is too tight. Check that the machine is threaded correctly. (1) Wrong side of fabric. (2) Right side of fabric. (3) Upper thread.
3. Open the extension table (1) on the front of the machine by lifting the bottom of the extension table up toward you and pulling. 4. Open the shuttle cover and remove the bobbin case by pulling its latch (1) toward you and pulling it out from the shuttle race. 5. Unwind about 4" of thread from the full bobbin.
How to oil the needle bar. 1. Select one needle bar at a time from the embroidery screen. 2. Turn the handwheel counterclockwise bringing the needle bar to its lowest position. 3. Put one drop of oil, as high as possible on the needle bar above the felt washer. (1) Apply oil here.
Follow the instructions below to properly install the bobbin: - Click here for video instructions. 1. Open the hook cover by pulling it toward you. 2. Pull the thread picker (1) toward you if it was no pulled toward the front. - To gain access to the bobbin case easily, pull the thread picker toward front. Thread picker is a device that is used ...
1. Check the needle by placing the flat side of the needle on a flat surface. - Check the needle from the top and the sides. 2. Press (needle position button) once or twice to raise the needle. 3. Place fabric or paper under the presser foot and cover the holes on the needle plate to prevent the needle from falling into the machine.
1. Turn the machine off. 2. Check the upper thread. - Check to see if your upper tension is too tight. Standard tension setting is 4. - Your thread could be caught on something between the needle and your spool of thread if so, your thread will be too tight for the needle to pick up the bobbin thread. - Make sure that the upper thread is ...