Search results
Results From The WOW.Com Content Network
In military engineering, earthworks are, more specifically, types of fortifications constructed from soil. Although soil is not very strong, it is cheap enough that huge quantities can be used, generating formidable structures. Examples of older earthwork fortifications include moats, sod walls, motte-and-bailey castles, and hill forts.
the discharge rate (Q) from the recharge rate (R) in a water balance as detailed in the article: hydrology (agriculture) the permissible long term average depth of the water table (Dw) on the basis of agricultural drainage criteria; the soil's hydraulic conductivity (Ka and Kb) by measurements; the depth of the bottom of the aquifer (Di)
This usually occurs two to three days after rain or irrigation in pervious soils of uniform structure and texture. The nominal definition of field capacity (expressed symbolically as θ fc) is the bulk water content retained in soil at −33 kPa (or −0.33 bar) of hydraulic head or suction pressure.
Summary of hydrologic and physical properties of rock and soil materials as analyzed by the Hydrologic Laboratory of the U.S. Geological Survey 1948-1960. U.S. Geological Survey Water Supply Paper 1839-D. 42 p. De Wiest, R. J. (1966). On the storage coefficient and the equations of groundwater flow. Journal of Geophysical Research, 71(4), 1117 ...
The bearing capacity of soil is the maximum average contact pressure between the foundation and the soil which should not produce shear failure in the soil. Ultimate bearing capacity is the theoretical maximum pressure which can be supported without failure; allowable bearing capacity is the ultimate bearing capacity divided by a factor of ...
This phenomenon of soil behaviour can be included in the Hardening Soil model by means of a dilatancy cut-off. In order to specify this behaviour, the initial void ratio, e i n i t {\displaystyle e_{init}} , and the maximum void ratio, e m a x {\displaystyle e_{max}} , of the material must be entered as general parameters.
Water pressure, u, is negative above and positive below the free water surface. If the soil pores are filled with water that is not flowing but is static, the pore water pressures will be hydrostatic. The water table is located at the depth where the water pressure is equal to the atmospheric pressure. For hydrostatic conditions, the water ...
Most soils have a dry bulk density between 1.0 and 1.6 g/cm 3 but organic soil and some porous clays may have a dry bulk density well below 1 g/cm 3. Core samples are taken by pushing a metallic cutting edge into the soil at the desired depth or soil horizon. The soil samples are then oven dried (often at 105 °C) until constant weight.