Search results
Results From The WOW.Com Content Network
Automixers balance multiple sound sources based on each source's level, quickly and dramatically adjusting the various signal levels automatically. [2] Automixers are used in live sound reinforcement to maintain a steady limit on the overall signal level of the microphones; if a public address system is set up so that one microphone will not feed back, then, in general, the automixer will ...
The distance from the sound source to the microphone is a critical element of GBF. Greater GBF is obtained with the performer closer to the microphone; an instance of the inverse-square law. If the performer reduces the distance to the microphone by half, the PAG is increased by 6 dB while the environmental sounds remain relatively the same. [3 ...
To maximize gain before feedback, the amount of sound energy that is fed back to the microphones must be reduced as much as is practical.As sound pressure falls off with 1/r with respect to the distance r in free space, or up to a distance known as reverberation distance in closed spaces (and the energy density with 1/r²), it is important to keep the microphones at a large enough distance ...
The measuring microphone is normally mounted on an unobtrusive boom (to avoid reflections) and positioned 1 metre in front of the drive units on the axis with the high-frequency driver. While this can produce repeatable results, such a 'free-space' measurement is not representative of performance in a room, especially a small room.
Another type of normalization is based on a measure of loudness, wherein the gain is changed to bring the average loudness to a target level. This average may be approximate, such as a simple measurement of average power (e.g. RMS), or more accurate, such as a measure that addresses human perception e.g. that defined by EBU R128 and offered by ReplayGain, Sound Check and GoldWave.
Audio feedback from microphones occurs when a microphone is too near a monitor or main speaker and the sound reinforcement system amplifies itself. Audio feedback through a microphone is almost universally regarded as a negative phenomenon, many electric guitarists use guitar feedback as part of their performance. This type of feedback is ...
This means that (1) moving the microphone closer to the sound source increases the signal level produced by the microphone, and (2) moving the microphone further away from undesirable noise sources will diminish the amount of noise in the microphone signal. Microphone placement is therefore an important aspect of gain staging [citation needed].
For sound reinforcement in live shows, mic bleed can make it hard for the sound engineer to control the levels of the different instruments and vocals onstage. For example, if an electric guitarist's loud amplifier is bleeding into the drum and vocal mics, it may be hard for the sound engineer to reduce the volume of the guitar in the onstage mix.