Search results
Results From The WOW.Com Content Network
A drill chuck is a specialised self-centering, three-jaw chuck, usually with capacity of 0.5 in (13 mm) or less, and rarely greater than 1 in (25 mm), used to hold drill bits or other rotary tools. This type of chuck is used on tools ranging from professional equipment to inexpensive hand and power drills for domestic use.
The Ridge Tool Company is an American manufacturing company that makes and distributes tools under the Ridgid brand name. The company was founded in 1923 in North Ridgeville, Ohio . [ 1 ] In 1943, it relocated to its current location in Elyria, Ohio , and in 1966, it became a wholly owned subsidiary of Emerson Electric .
At this point, the Hole-Shooter, a drill that weighed 5 lbs. was created by A. H. Peterson. The Peterson Company eventually went bankrupt after a devastating fire and recession , but the company was auctioned off to A. F. Siebert, [ 21 ] a former partner in the Peterson Company, in 1924 and became the Milwaukee Electric Tool Company .
Run-out is dynamic and cannot be compensated. If a rotating component, such as a drill chuck, does not hold the drill centrally, then as it rotates the rotating drill will turn about a secondary axis. Run-out has two main forms: [2] Radial run-out is caused by the tool being translated off the machine axis, still parallel.
Turning the spindle of the chuck in a clockwise direction tightens the drill bit in the chuck; turning counterclockwise loosens the bit for removal. A carpenter using a brace. In most modern braces, immediately behind the chuck is a three position gear release that allows ratcheting of the handle when in tight spots. Turning the gear release ...
A hand-held corded electric drill A lightweight magnetic-mount drill. A drill is a tool used for making round holes or driving fasteners. It is fitted with a bit, either a drill or driver chuck. Hand-operated types are dramatically decreasing in popularity and cordless battery-powered ones proliferating due to increased efficiency and ease of use.
The triangle shank is almost always made by machining three flats on round bar stock. It is intended as a minor modification of a straight shank, still allowing it to be held in a 3-jaw drill chuck, but allowing higher torque transmission and limited slipping. Can be held in a drill chuck; High torque transmission; Moderately accurate centering
The drill will grasp the upper end of a bit called the shank in the chuck. Drills come in standardized drill bit sizes. A comprehensive drill bit and tap size chart lists metric and imperial sized drills alongside the required screw tap sizes. There are also certain specialized drill bits that can create holes with a non-circular cross-section. [1]