Ad
related to: cisco ospf configuration example
Search results
Results From The WOW.Com Content Network
Open Shortest Path First (OSPF) is a routing protocol for Internet Protocol (IP) networks. It uses a link state routing (LSR) algorithm and falls into the group of interior gateway protocols (IGPs), operating within a single autonomous system (AS). OSPF gathers link state information from available routers and constructs a topology map of the ...
The Cisco Internetwork Operating System enables network administrators to modify the distance by changing the distance value in sub-router configuration mode. In the example below, RIP's administrative distance is changed to 89 so that it used in preference to OSPF. [3]
In the Cisco IOS, [1] they are used in several places, for example: To indicate the size of a network or subnet for some routing protocols, such as OSPF. To indicate what IP addresses should be permitted or denied in access control lists (ACLs). A wildcard mask can be thought of as an inverted subnet mask.
The technique was later adapted for use in the contemporary link-state routing protocols IS-IS and OSPF. Cisco literature refers to Enhanced Interior Gateway Routing Protocol (EIGRP) as a "hybrid" protocol, [12] despite the fact it distributes routing tables instead of topology maps. However, it does synchronize routing tables at start-up as ...
An interior gateway protocol (IGP) or interior routing protocol is a type of routing protocol used for exchanging routing table information between gateways (commonly routers) within an autonomous system (for example, a system of corporate local area networks). [1] This routing information can then be used to route network-layer protocols like IP.
An IP-based routing protocol, EIGRP, OSPF, RIPv2, BGP or ODR (DMVPN hub-and-spoke only). [5] Generic Routing Encapsulation (GRE), RFC 1701, or multipoint GRE if spoke-to-spoke tunnels are desired; IPsec (Internet Protocol Security) using an IPsec profile, which is associated with a virtual tunnel interface in IOS software.
Link-state routing protocols such as Open Shortest Path First (OSPF) and Intermediate System to Intermediate System (IS-IS) elect a designated router on every link to perform flooding of topology information. In wireless ad hoc networks, there is different notion of a link, packets can and do go out the same interface; hence, a different ...
The opaque LSAs, types 9, 10, and 11, are designated for upgrades to OSPF for application-specific purposes. For example, OSPF-TE has traffic engineering extensions to be used by RSVP-TE in Multiprotocol Label Switching (MPLS). Opaque LSAs are used to flood link color and bandwidth information.