Ad
related to: cv axle clicking when turning wheel on ford
Search results
Results From The WOW.Com Content Network
Early front-wheel drive vehicles (such as the 1930s Citroen Traction Avant) and the front axles of off-road four-wheel drive vehicles used universal joints rather than CV joints. Amongst the first cars to use CV joints were the 1926 Tracta , the 1931 DKW F1 and the 1932 Adler Trumpf , all of which were front-wheel drive and used the Tracta ...
If articulation is limited, one wheel on an axle may be lifted off the ground by rough terrain, thus losing all traction to all wheels (all power goes to the lifted wheel, which spins freely). A rear locking differential is often supplied to make up for this compromise – if a wheel is lifted off the ground, the locking differential can be ...
Each half axle connects to the wheel by use of a constant velocity (CV) joint which allows the wheel assembly to move freely vertically as well as to pivot when making turns. In rear-wheel drive cars and trucks, the engine turns a driveshaft (also called a propeller shaft or tailshaft ) which transmits the rotational force to a drive axle at ...
When the front hubs are locked, even if no power is sent to the front axle (by means of a transfer case), the turning of the wheels will still spin the front axle, differential, and driveshaft, which puts extra load on the engine. Unlocking the hubs disconnects the wheels from the axle, which eliminates this extra load.
Its design is similar to the Torsen T-2 (slightly less torque bias), and is an aftermarket part for many popular US-made solid axles for rear-wheel drive and 4x4 pick-up trucks. The Truetrac is most often used in the front axle of 4x4 pick-up trucks intended for off-road use, in combination with locking center and rear differentials.
The Dana Holding Corporation manufactured the TTB axle for Ford. It uses a universal joint in the center that allows the wheels to move independently of each other. The differential is offset to the driver's side, and a slip yoke is used on the long axle side to allow the shaft to change length.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The housing material is Gray iron in early axles and Ductile iron in later axles. GM and Ford Dana 60 axles utilize locking hubs. Dodge Dana 60 axles utilized locking hubs until 1994 when a Center Axle Disconnect (CAD) system was adopted. However, model year 2002 Rams phased out the CAD system leaving some 2002 Dana 60 axles permanently locked in.