Ads
related to: 120a bat to aux fuse cross reference littelfuse
Search results
Results From The WOW.Com Content Network
A reference designator unambiguously identifies the location of a component within an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. C3, D1, R4, U15.
Automotive fuses are typically housed inside one or more fuse boxes (also called an integrated power module (IPM)) within the vehicle, typically on one side of the engine compartment and/or under the dash near the steering wheel. Some fuses or circuit breakers may nonetheless be placed elsewhere, such as near the cabin fan or air bag controller.
In 1976, Littelfuse developed Autofuse, which was the first blade-type fuse used in automobiles. [5] The Autofuse brand was counterfeited heavily and in 1983 the company obtained an exclusionary order from the United States International Trade Commission , which barred the importation of counterfeit blade-type fuses.
An automobile auxiliary power outlet (also known as car cigarette lighter or auxiliary power outlet [1]) in an automobile was initially designed to power an electrically heated cigarette lighter, [1] but became a de facto standard DC connector to supply electrical power for portable accessories used in or near an automobile directly from the ...
A time-delay fuse (also known as an anti-surge or slow-blow fuse) is designed to allow a current which is above the rated value of the fuse to flow for a short period of time without the fuse blowing. These types of fuse are used on equipment such as motors, which can draw larger than normal currents for up to several seconds while coming up to ...
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
An antifuse is an electrical device that performs the opposite function to a fuse.Whereas a fuse starts with a low resistance and is designed to permanently break or open an electrically conductive path (typically when the current through the path exceeds a specified limit), an antifuse starts with a high resistance—an open circuit—and programming it converts it into a permanent ...