When.com Web Search

  1. Ads

    related to: how to set tp-link repeater setup

Search results

  1. Results From The WOW.Com Content Network
  2. Wireless distribution system - Wikipedia

    en.wikipedia.org/wiki/Wireless_distribution_system

    They may be configured to different service set identifiers (SSIDs). WDS also requires every base station to be configured to forward to others in the system. WDS may also be considered a repeater mode because it appears to bridge and accept wireless clients at the same time (unlike traditional bridging). However, with the repeater method ...

  3. Wireless repeater - Wikipedia

    en.wikipedia.org/wiki/Wireless_repeater

    Since only one wireless device can transmit at once, wireless transmissions are doubled (router to the repeater and then repeater to the client versus just router to the client), and so: Wireless throughput is reduced by at least 50%. [1] Wireless interference (e.g., with other networks on the same channel) is at least doubled.

  4. Wireless access point - Wikipedia

    en.wikipedia.org/wiki/Wireless_access_point

    Cisco Aironet wireless access point. In computer networking, a wireless access point (WAP) (also just access point (AP)) is a networking hardware device that allows other Wi-Fi devices to connect to a wired network or wireless network.

  5. Wi-Fi - Wikipedia

    en.wikipedia.org/wiki/Wi-Fi

    A service set is the set of all the devices associated with a particular Wi-Fi network. Devices in a service set need not be on the same wavebands or channels. A service set can be local, independent, extended, mesh, or a combination. Each service set has an associated identifier, a 32-byte service set identifier (SSID), which identifies the ...

  6. Ethernet over twisted pair - Wikipedia

    en.wikipedia.org/wiki/Ethernet_over_twisted_pair

    The distances that single pair operates at full duplex depends on the speed: 1000m (1km) with 802.3cg-2019 10BASE-T1L; 15 m or 49 ft with 100BASE-T1 (link segment type A); up to 40 m or 130 ft using 1000BASE-T1 link segment type B with up to four in-line connectors. Both physical layers require a balanced twisted pair with an impedance of 100 Ω.

  7. Amateur radio repeater - Wikipedia

    en.wikipedia.org/wiki/Amateur_radio_repeater

    An amateur radio repeater system consisting of a 70 cm repeater and a 2-meter digipeater and iGate. Coaxial cavity RF filter at 2 meter repeater An amateur radio repeater is an electronic device that receives a weak or low-level amateur radio signal and retransmits it at a higher level or higher power, so that the signal can cover longer ...