Search results
Results From The WOW.Com Content Network
Its solid-lifter cam, known as the "30-30 Duntov" cam named after its 0.03 in (0.8 mm)/0.030 in hot intake/exhaust valve-lash and Zora Arkus-Duntov (the first Duntov cam was the 0.012 in (0.3 mm)/0.018 in (0.5 mm) 1957 grind known as the '097, which referred to the last three digits of the casting number) the "Father of the Corvette", was also ...
It also features higher flowing cylinder heads sourced from the L92, a more aggressive camshaft with 0.551 in (14 mm) lift, a 10.7:1 compression ratio, a revised valvetrain with 0.236 in (6 mm) offset intake rocker arms, a high-flow intake manifold, and 47 lb (21 kg)/hour fuel injectors from the LS7 engine.
A redesigned cylinder head and manifold for improved air flow. Variable exhaust valve timing (the LW2 engine only had variable intake valve timing) Specially-developed fuel injectors. New pistons with pentroof-style centre-domes and valve eyelets for a higher compression ratio of 12.2:1 (compared to 10.2:1 for the dual fuel engine).
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
Ford offered a performance head that was a stock part on 1993–1995 Mustang Cobra models and pre-1997 ½ Ford Explorers and Mercury Mountaineers equipped with the 5.0 L engine called the GT-40 head (casting ID F3ZE-AA). In mid-1997, the Explorer and Mountaineer 5.0 L heads were revised and renamed GT40P.
An evolution of the 1964 DOHC prototype “XJ13” engine, the Jaguar V12 engine is a family of SOHC internal combustion V12 engines with a common block design, that were mass-produced by Jaguar Cars for a quarter of a century, from 1971 to 1997, mostly as 5.3‑litres, but later also as 6‑litres, and 7‑litre versions that were deployed in racing.
The firing order has been changed from that shared by all previous Modular V8s (1-3-7-2-6-5-4-8) to that of the Ford Flathead V8 (1-5-4-8-6-3-7-2). [17] Compression ratio is 11.0:1, and despite having port fuel injection (as opposed to direct injection ) the engine can still be run on 87 octane gasoline.
A hemispherical head ("hemi-head") gives an efficient combustion chamber with minimal heat loss to the head, and allows for two large valves.However, a hemi-head usually allows no more than two valves per cylinder due to the difficulty in arranging the valve gear for four valves at diverging angles, and these large valves are necessarily heavier than those in a multi-valve engine of similar ...