Ad
related to: electrical conductivity of sulphur paint in air flow sensor symptomsexair.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
A corona discharge is an electrical discharge caused by the ionization of a fluid such as air surrounding a conductor carrying a high voltage. It represents a local region where the air (or other fluid) has undergone electrical breakdown and become conductive, allowing charge to continuously leak off the conductor into the air.
Electrical conductivity of water samples is used as an indicator of how salt-free, ion-free, or impurity-free the sample is; the purer the water, the lower the conductivity (the higher the resistivity). Conductivity measurements in water are often reported as specific conductance, relative to the conductivity of pure water at 25 °C.
Antistatic agents can be added to nonpolar solvents to increase their conductivity to allow electrostatic spray painting. (Oxygenated solvents have too high conductivity to be used here.) [ 9 ] The polysulfones can be prepared by reacting olefins , notably alpha-olefins , with sulfur dioxide .
Electrical overstress failures can be classified as thermally-induced, electromigration-related and electric field-related failures; examples of such failures include: Thermal runaway , where clusters in the substrate cause localised loss of thermal conductivity , leading to damage producing more heat; the most common causes are voids caused by ...
In the petrochemical industry, 50 pS/m is the recommended minimum value of electrical conductivity for adequate removal of charge from a fluid. Kerosines may have conductivity ranging from less than 1 picosiemens per meter to 20 pS/m. For comparison, deionized water has a conductivity of about 10,000,000 pS/m or 10 μS/m. [22]
Variations in the electrical conductivity and magnetic permeability of the test object, and the presence of defects causes a change in eddy current and a corresponding change in phase and amplitude that can be detected by measuring the impedance changes in the coil, which is a telltale sign of the presence of defects. [5]
The first use of corona discharge to remove particles from an aerosol was by Hohlfeld in 1824. [2] However, it was not commercialized until almost a century later. In 1907 Frederick Gardner Cottrell, a professor of chemistry at the University of California, Berkeley, applied for a patent on a device for charging particles and then collecting them through electrostatic attraction—the first ...
In electrical engineering, partial discharge (PD) is a localized dielectric breakdown (DB) (which does not completely bridge the space between the two conductors) of a small portion of a solid or fluid electrical insulation (EI) system under high voltage (HV) stress.