When.com Web Search

  1. Ads

    related to: minimum temperature to prevent damp
    • For Warehouses

      Experts in GDP/CEIV compliance.

      Simplified monitoring procedure.

    • For Laboratories

      Automatic data logging and reports.

      Accredited calibration service.

    • For Biotech

      Compliance guarantee.

      Automated document generation.

    • For Pharma

      Fulfil GMP/GDP/CEIV compliance.

      Simplified auditing process.

Search results

  1. Results From The WOW.Com Content Network
  2. Wood drying - Wikipedia

    en.wikipedia.org/wiki/Wood_drying

    The temperature sensing element of this thermometer is kept moist with a porous fabric sleeve (cloth) usually put in a reservoir of clean water. A minimum air flow of 2 m/s is needed to prevent a zone of stagnant damp air formation around the sleeve (Walker et al., 1993). Since air passes over the wet sleeve, water is evaporated and cools the ...

  3. Damp (structural) - Wikipedia

    en.wikipedia.org/wiki/Damp_(structural)

    Rising damp is widely referred to in Victorian literature and the Public Health Act of 1875 introduced the requirement for a damp-proof course in walls to prevent rising damp. [14] An entry in the British Medical Journal from 1872 describes the phenomenon of rising damp as follows:

  4. Dew point - Wikipedia

    en.wikipedia.org/wiki/Dew_point

    The more moisture the air contains, the higher its dew point. [4] When the temperature is below the freezing point of water, the dew point is called the frost point, as frost is formed via deposition rather than condensation. [5] In liquids, the analog to the dew point is the cloud point.

  5. Dry rot treatment - Wikipedia

    en.wikipedia.org/wiki/Dry_rot_treatment

    Dry rot is spread by spores which are present in most buildings. The minimum moisture content of timber for spore germination is 28–30% (lower than other rots), and the relative humidity must be in excess of 95%. Spores are resistant to desiccation and may still be viable for germination when they are several years old. [2]

  6. Vapor barrier - Wikipedia

    en.wikipedia.org/wiki/Vapor_barrier

    A slab-on-grade or basement floor should be poured over a cross-laminated polyethylene vapor barrier over 4 inches (10 cm) of granular fill to prevent wicking of moisture from the ground and radon gas incursion. Inside a steel building, water vapor will condense whenever it comes into contact with a surface that is below the dew point temperature.

  7. What should you set your heat to in the winter? Avoid ... - AOL

    www.aol.com/set-heat-winter-avoid-thermostat...

    The World Health Organization recommends keeping indoor temperatures between 64 and 75 degrees for healthy people. But for those who are very young, elderly or who have health problems, the ...