Ads
related to: 12 volt automotive tester toolipatools.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
The OBD-II specification provides for a standardized hardware interface — the female 16-pin (2x8) J1962 connector, where type A is used for 12-volt vehicles and type B for 24-volt vehicles. Unlike the OBD-I connector, which was sometimes found under the bonnet of the vehicle, the OBD-II connector is required to be within 2 feet (0.61 m) of ...
A test light, test lamp, voltage tester, or mains tester is a piece of electronic test equipment used to determine the presence of electricity in a piece of equipment under test. A test light is simpler and less costly than a measuring instrument such as a multimeter , and often suffices for checking for the presence of voltage on a conductor.
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
ecu.test automates the control of the whole test environment and supports a broad range of test tools. Various abstraction layers for measured quantities allow its application on different testing levels, e.g. within the context of model in the loop, software in the loop and hardware in the loop as well as in real systems (vehicle and driver in the loop).
For the 12 volt systems, the center contact is the positive terminal and the shell is the negative terminal. Most automobiles connect the negative terminal to the frame of the vehicle (negative ground). 12 volt auto connectors are made to comply with a standard by Underwriters Laboratories for safety. UL2089 was developed to cover the ...
A host of functions required for ECU software calibration, such as interface-dependent calibration methods, calibration data management, measurement data visualization and analysis, ECU programming, vehicle bus monitoring, as well as remote control through standard interfaces, are part of the product's functional complement.
to test series and interpoles (commutating) fields from a DC motor; to determine phasing and polarity in multiwinding armatures; to test rotors in rotating frequency changers, as well as in wound rotors; to test shorts between turns in taped coils before installation into an armature or a stator; as a low voltage isolation transformer
Entry-level cable testers are essentially continuity testers. A continuity tester is an item of electrical test equipment used to determine if an electrical path can be established between two points; [1] that is if an electrical circuit can be made. The circuit under test is completely de-energized prior to connecting the apparatus. [1]