Search results
Results From The WOW.Com Content Network
The Mark 32 can fire 12.75-inch (324 mm) torpedoes of the Mark 44, Mark 46, Mark 50 (from the Mod 17 tubes onwards), [3] [4] and Mark 54 [citation needed] designs, and can be modified to use other torpedoes (such as the MU90 Impact aboard Royal Australian Navy frigates, or Royal Navy units using Sting Ray torpedoes).
The Mark 32 was withdrawn from service use with the introduction of the Mark 43 torpedo. Ten were manufactured by Leeds & Northrup , Philadelphia during War II, and about 3,300 were manufactured by a combination of the Philco Corporation , Philadelphia, and the Naval Ordnance Plant , Forest Park, Illinois .
These included the Mark 14, Mark 23, Mark 32, Mark 34, Mark 37, Mark 44, and Mark 46. Additionally, US Navy rocket-boosted torpedo systems were imported, such as the ASROC and VL-ASROC . [ 2 ] This page presently only lists weapons which were indigenously produced in Japan, including both original designs and locally manufactured foreign designs.
The Mark 50 torpedo is a U.S. Navy advanced lightweight torpedo for use against fast, deep-diving submarines. The Mk 50 can be launched from all anti-submarine aircraft and from torpedo tubes aboard surface combatant ships. The Mk 50 was intended to replace the Mk 46 as the fleet's lightweight torpedo. [1]
All 3-inch/50 cal gun mounts were removed, and the after superstructure was used for the DASH's hangar and flight deck, with two new triple Mark 32 torpedo tubes for the 12.75-inch Mk.44 torpedo [3] placed just behind the rear funnel. This modernization was designed to extend the life of the destroyer by at least eight years.
The torpedoes used Mark 46 silver oxide batteries. These had a known tendency to overheat, occasionally igniting or exploding. Training torpedoes used rechargeable secondary batteries. For a long time, the Mark 37 was a primary U.S. submarine-launched ASW torpedo. It was replaced by the Mark 48 starting in 1972. The remaining inventory was then ...
The 16-inch Mark 2 was 50 calibers long, with a liner, an A tube, jacket and seven hoops with four hoop locking rings and a screw box liner. The Mod 0 used an increasing twist in the rifling while the Mod 1 used a uniform twist and a different groove pattern. The Mark 3 was the same as the Mark 2 but used a one-step conical liner.
The Mark 48 was initially developed as REsearch TORpedo Concept II (RETORC II), one of several weapons recommended for implementation by Project Nobska, a 1956 summer study on submarine warfare. [9] The Mk-48 torpedo was designed at the end of the 1960s to keep up with the advances in Soviet submarine technology.