When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Run-out - Wikipedia

   en.wikipedia.org/wiki/Run-out

   Radial run-out is caused by the tool being translated off the machine axis, still parallel. Radial run-out will measure the same all along the machine axis. Axial run-out is caused by the tool or component being at an angle to the axis. Axial run-out causes the tip of the tool or shaft to rotate off-centre relative to the base.

3. Insertion mount machine - Wikipedia

   en.wikipedia.org/wiki/Insertion_mount_machine

   An axial inserter takes axial leaded through-hole components from reels which are fed into dispensing heads that cut the parts onto a chain in the order of insertion; transferred from the sequence chain to the insertion chain, which brings the component underneath the insertion head which then cuts the leads of the component to the correct length for lead length and insertion span; bends the ...

4. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   The closer on a manual lathe is either lever-style or handwheel-style. The closer on a CNC lathe is powered (electric, hydraulic, or pneumatic), and it may be controlled by various means: a foot pedal that the operator steps on when desired; a line in the program (for opening and closing under program control); or a button on the control panel.

5. Machining - Wikipedia

   en.wikipedia.org/wiki/Machining

   Machining is a form of subtractive manufacturing, [1] which utilizes machine tools, in contrast to additive manufacturing (e.g. 3D printing), which uses controlled addition of material. Machining is a major process of the manufacture of many metal products, but it can also be used on other materials such as wood , plastic , ceramic , and ...

6. Through-hole technology - Wikipedia

   en.wikipedia.org/wiki/Through-hole_technology

   Through-hole (leaded) resistors. In electronics, through-hole technology (also spelled "thru-hole") is a manufacturing scheme in which leads on the components are inserted through holes drilled in printed circuit boards (PCB) and soldered to pads on the opposite side, either by manual assembly (hand placement) or by the use of automated insertion mount machines.

7. Spline (mechanical) - Wikipedia

   en.wikipedia.org/wiki/Spline_(mechanical)

   where the sides of the equally spaced grooves are parallel in both directions, radial and axial. Involute spline where the sides of the equally spaced grooves are involute, as with an involute gear, but not as tall. The curves increase strength by decreasing stress concentrations. Crowned splines