Search results
Results From The WOW.Com Content Network
In the hydrostatic extrusion process the billet is completely surrounded by a pressurized liquid, except where the billet contacts the die. This process can be done hot, warm, or cold, however the temperature is limited by the stability of the fluid used. The process must be carried out in a sealed cylinder to contain the hydrostatic medium.
An ore extraction process broken into its constituent unit operations (Quincy Mine, Hancock, MI ca. 1900) In chemical engineering and related fields, a unit operation is a basic step in a process. Unit operations involve a physical change or chemical transformation such as separation, crystallization, evaporation, filtration, polymerization ...
Microextrusion is an outgrowth of microforming, a science that was in its infancy in the early 1990s. In 2002, Engel et al. expressed that up to that point, only a few research experiments involving micro-deep drawing and extruding processes had been attempted, citing limitations in shearing on billets and difficulties in tool manufacturing and handling. [1]
During an extrusion process it is essential to consider the surface finish of exposed product surfaces. As a general rule, the narrower an exposed surface, the more uniform its finish becomes. Webs, flanges and abrupt changes in metal thickness may show up as marks on the opposite surface of an extrusion, particularly on thin sections. The ...
Plastics extrusion is a high-volume manufacturing process in which raw plastic is melted and formed into a continuous profile. Extrusion produces items such as pipe/tubing, weatherstripping , fencing, deck railings , window frames , plastic films and sheeting, thermoplastic coatings, and wire insulation.
A rheometer is a laboratory device used to measure the way in which a viscous fluid (a liquid, suspension or slurry) flows in response to applied forces. It is used for those fluids which cannot be defined by a single value of viscosity and therefore require more parameters to be set and measured than is the case for a viscometer .
The direct spinning process avoids the stage of solid polymer pellets. The polymer melt is produced from the raw materials, and then from the polymer finisher directly pumped to the spinning mill. Direct spinning is mainly applied during production of polyester fibers and filaments and is dedicated to high production capacity (>100 ton/day).
In industrial metalworking, it is an extrusion process, [3] The technique is able to refine the microstructure of metals and alloys, thereby improving their strength according to the Hall-Petch relationship. This process improves not only the strength but also other properties such as corrosion and wear resistance of alloys and compounds.