Search results
Results From The WOW.Com Content Network
In direct extrusion the billet is pushed through the die with ram pressure, whereas in indirect extrusion a die moves relative to the container. Rule based analysis of extrusion process would help to determine a set of rules essential for consideration while designing a product, or even during cost estimation of a product.
Microextrusion is a microforming extrusion process performed at the submillimetre range. Like extrusion, metal is pushed through a die orifice, but the resulting product's cross section can fit through a 1 mm square. Several microextrusion processes have been developed since microforming was envisioned in 1990.
An Automatic Oil Muffle Furnace, circa 1910. Petroleum is contained in tank A, and is kept under pressure by pumping at intervals with the wooden handle, so that when the valve B is opened, the oil is vaporized by passing through a heating coil at the furnace entrance, and when ignited burns fiercely as a gas flame.
Microextrusion is an outgrowth of microforming, a science that was in its infancy in the early 1990s. In 2002, Engel et al. expressed that up to that point, only a few research experiments involving micro-deep drawing and extruding processes had been attempted, citing limitations in shearing on billets and difficulties in tool manufacturing and handling. [1]
Friction extrusion is a thermo-mechanical process that can be used to form fully consolidated wire, rods, tubes, or other non-circular metal shapes directly from a variety of precursor charges including metal powder, flake, machining waste (chips or swarf) or solid billet.
Extrusion is a manufacturing process used to make pipes, hoses, drinking straws, curtain tracks, rods, and fibre. [1] The granules melt into a liquid which is forced through a die, forming a long 'tube like' shape. The shape of the die determines the shape of the tube. The extrusion is then cooled and forms a solid shape.
This type of liposome extruder is primarily used in research laboratories, as it can process mini-sample volumes between 0.25 ml and 2.5 ml. The hand-driven liposome extruders are further categorized into liposome extruders with a thermal-jacketed option and liposome extruders under ambient temperature.
Plastics extrusion is a high-volume manufacturing process in which raw plastic is melted and formed into a continuous profile. Extrusion produces items such as pipe/tubing, weatherstripping , fencing, deck railings , window frames , plastic films and sheeting, thermoplastic coatings, and wire insulation.