Search results
Results From The WOW.Com Content Network
The federal weight limits for CMVs are 80,000 pounds (36,000 kg) for gross weight (unless the bridge formula dictates a lower limit), 34,000 pounds (15,000 kg) for a tandem axle, and 20,000 pounds (9,100 kg) for a single axle. [9] A tandem axle is defined as two or more consecutive axles whose centers are spaced more than 40 inches (102 cm) but ...
A tandem rolling mill is a rolling mill used to produce wire and sheet metal. It is composed of two or more close-coupled [ clarification needed ] stands, and uses tension between the stands as well as compressive force from work rolls [ clarification needed ] to reduce the thickness of steel.
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.
In the attached photo of a 5-link live axle suspension, the different types of links can be seen. These links work in tandem with the coil springs, dampers, and sway bar to control all six degrees of freedom of the axle. The upper links (orange) and the lower links (yellow) work in tandem to control the pitch, yaw and the fore and aft movement ...
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.
Comparison between normal and portal axles Pinzgauer portal axle. A portal axle (or portal gear lift) is an off-road vehicle suspension and drive technology where the axle tube or the half-shaft is offset from – usually above – the center of the wheel hub and where driving power is transferred to each wheel via a simple gearbox, built onto each hub. [1]
A swing axle is a simple type of independent suspension designed and patented by Edmund Rumpler in 1903 for the rear axle of rear wheel drive vehicles. This was a revolutionary invention in automotive suspension, allowing driven (powered) wheels to follow uneven road surfaces independently, thus enabling the vehicle's wheels to maintain better ...
The axle receives its vertical and transverse support from a transverse leaf spring (leaf springs were often used for support in more than one direction), and its longitudinal support from fore-aft links sometimes called "radius rods" which are attached (via pivots) to the ends of the axle at their forward end and to the sides of the chassis ...