Ads
related to: gas valve with manometer portamazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
For example, a 1-inch-diameter (25 mm) valve would be lifted a maximum of 0.350 inch. During flow testing the valve would be set at L/D 0.05 0.1 0.15 0.2 0.25 0.3 and readings taken successively. This allows the comparison of efficiencies of ports with other valve sizes, as the valve lift is proportional rather than absolute.
Venturi scrubbers are used to clean flue gas emissions; Injectors (also called ejectors) are used to add chlorine gas to water treatment chlorination systems; Steam injectors use the Venturi effect and the latent heat of evaporation to deliver feed water to a steam locomotive boiler. Sandblasting nozzles accelerate and air and media mixture
Boston valve: three-part two-port check valve used on inflatable boats, air mattresses, airbeds etc.; available in two sizes, normal and small; Ceramic valve, used mainly in high duty cycle applications or on abrasive fluids. Ceramic disc can also provide Class IV seat leakage; Cock: colloquial term for a small valve or a stopcock
The inlet pressure gauge will indicate this pressure. The gas then passes through the normally open pressure control valve orifice and the downstream pressure rises until the valve actuating diaphragm is deflected sufficiently to close the valve, preventing any more gas from entering the low pressure side until the pressure drops again.
This example, from an Airbus A380, combines a pitot tube (right) with a static port and an angle-of-attack vane (left). Air-flow is right to left. Types of pitot tubes A pitot-static tube connected to a manometer Pitot tube on Kamov Ka-26 helicopter A Formula One car during testing with frames holding many pitot tubes Location of pitot tubes on ...
The gas-lift mandrel is a device installed in the tubing string of a gas-lift well onto which or into which a gas-lift valve is fitted. There are two common types of mandrels. In a conventional gas-lift mandrel, a gas-lift valve is installed as the tubing is placed in the well. Thus, to replace or repair the valve, the tubing string must be pulled.