Search results
Results From The WOW.Com Content Network
The decreasing cost and better performance of integrated circuits has led to serial links being used in favor of parallel links; for example, IEEE 1284 printer ports vs. USB, Parallel ATA vs. Serial ATA, and FireWire or Thunderbolt are now the most common connectors for transferring data from audiovisual (AV) devices such as digital cameras or ...
A serial port is a serial communication interface through which information transfers in or out sequentially one bit at a time. [1] This is in contrast to a parallel port , which communicates multiple bits simultaneously in parallel .
Serial communication is used for all long-haul communication and most computer networks, where the cost of cable and difficulty of synchronization make parallel communication impractical. Serial computer buses have become more common even at shorter distances, as improved signal integrity and transmission speeds in newer serial technologies ...
In computing, a parallel port is a type of interface found on early computers (personal and otherwise) for connecting peripherals. The name refers to the way the data is sent; parallel ports send multiple bits of data at once (parallel communication), as opposed to serial communication, in which bits are sent one at a
Parallel ports send multiple bits at the same time over several sets of wires. Serial ports send and receive one bit at a time via a single wire pair (Ground and +/-). After ports are connected, they typically require handshaking, where transfer type, transfer rate, and other necessary information is shared before data is sent.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
In general, parallel interfaces are quoted in B/s and serial in bit/s. The more commonly used is shown below in bold type. On devices like modems , bytes may be more than 8 bits long because they may be individually padded out with additional start and stop bits; the figures below will reflect this.
For example, on the original IBM PC, a male D-sub was an RS-232-C DTE port (with a non-standard current loop interface on reserved pins), but the female D-sub connector on the same PC model was used for the parallel "Centronics" printer port. Some personal computers put non-standard voltages or signals on some pins of their serial ports.