Ads
related to: radial vs belted tires
Search results
Results From The WOW.Com Content Network
A cross-section of a tire. Number 12 indicates the radial ply. Numbers 14 and 16 are bias plies. A radial tire (more properly, a radial-ply tire) is a particular design of vehicular tire. In this design, the cord plies are arranged at 90 degrees to the direction of travel, or radially (from the center of the tire).
The Goodyear Polyglas tire was a bias-belted tire announced in 1967 by Goodyear. "Polyglas" was a registered trademark. [2] The tire combined some characteristics of both bias-ply and radial-ply tires. They had a wider tread than most other tires on the market then and used fiberglass belts.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
The "belted" tire starts two main plies of polyester, rayon, or nylon annealed as in conventional tires, and then placed on top are circumferential belts at different angles that improve performance compared to non-belted bias tires. The belts may be fiberglass or steel. [57]
Tire forces are divided into three axes: radial, lateral, and tangential (or fore-aft). The radial axis runs from the tire center toward the tread, and is the vertical axis running from the roadway through the tire center toward the vehicle. This axis supports the vehicle's weight. The lateral axis runs sideways across the tread.
The tire featured a whitewall on one side and a redline on the other, also common on the tire market at the time. The tire achieved relatively good sales being that Seiberling's Akron rivals had released good products to compete, including Goodyear 's Polyglas, Firestone 's Wide-Oval, Uniroyal 's Tiger Paw and BFGoodrich 's Radial T/A.