Search results
Results From The WOW.Com Content Network
During the early 1980s, when GM was streamlining their engine lineups, the Chevrolet 305 would rise to prominence as General Motors' "corporate" engine, signified by being the standard (and often only) V8 in many GM vehicles. Through much of the 1980s, the 305 became General Motors' most common V8, followed closely by Oldsmobile's 307.
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...
This page was last edited on 3 November 2015, at 15:03 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may apply.
Chevrolet Performance created the 454 big-block Chevy race engine in 1970 and continued production of the crate engine through 2001. The addition of EFI and picking up the Vortec 7400 name took place in 1996 which was replaced with the Vortec 8100 platform once the 7400 was retired.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
The LQ1 (also called the Twin Dual Cam or TDC) was a 3.4 L (3,350 cc) DOHC V6 engine ("X-code") based on the aluminum-headed second generation of GM's 60° engine line, sharing a similar block with its pushrod cousins, the 3.1 L LH0 V6 and the then recently retired 2.8 L (2,837 cc) LB6 V6.
1977–2013 Chevrolet 90° V6 engine (derived from the Chevrolet Small-Block" V8; now marketed as GM Vortec V6 or Vortec 4300 or EcoTec3 V6) 1979–2010 Chevrolet 60-Degree V6; 1994–2005 Opel 54-Degree L81 V6 (used in the Saturn Vue, Cadillac Catera and Saturn L series) 1995–present Suzuki H (used in several models built for GM by Suzuki)
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.