Ad
related to: spur gear geometry
Search results
Results From The WOW.Com Content Network
Spur gear. Spur gears or straight-cut gears are the simplest type of gear. They consist of a cylinder or disk with teeth projecting radially. Viewing the gear at 90 degrees from the shaft length (side on) the tooth faces are straight and aligned parallel to the axis of rotation. Looking down the length of the shaft, a tooth's cross section is ...
Spur gear. In a cylindrical spur gear or straight-cut gear, the tooth faces are straight along the direction parallel to the axis of rotation. Any imaginary cylinder with the same axis will cut the teeth along parallel straight lines. The teeth can be either internal or external. Two spur gears mesh together correctly only if fitted to parallel ...
Meshing of two spur gears with involute external teeth. z 1 = 20, z 2 = 50, α = 20°, ξ 1 = ξ 2 = 0, ISO 53:1998. The lower (green) gear is the driving one. The line of contact, which is the locus of all teeth contact points, is shown in blue.
A face gear set typically consists of a disk-shaped gear, grooved on at least one face, in combination with a spur, helical, or conical pinion. A face gear has a planar pitch surface and a planar root surface, both of which are perpendicular to the axis of rotation. [ 1 ]
Spur-gear differential. A spur-gear differential has equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the ...
In particular, a crown gear is a type of bevel gear where the pitch cone angle is 90 degrees. [1] [2] A pitch cone of any other angle is simply called a bevel gear. [3] Crown gears normally mesh with other bevel gears, or sometimes spur gears, a typical use being a crown gear and pinion system which allows a rotary motion to be shifted 90 degrees.
Bevel gears are gears where the axes of the two shafts intersect and the tooth-bearing faces of the gears themselves are conically shaped. Bevel gears are most often mounted on shafts that are 90 degrees apart, but can be designed to work at other angles as well. [1] The pitch surface of bevel gears is a cone, known as a pitch cone. Bevel gears ...
A line drawing of a spur gear with an involute profile. This was drawn in Solid Edge and Inkscape using Unwin's Construction. The pitch diameter is 12mm and there are 18 teeth, giving a module of 2/3. Date: 25 August 2007: Source: Self-made