Search results
Results From The WOW.Com Content Network
The citadel consisting of the magazines and engine rooms was protected by an STS outer hull plating 1.5 inches (38 mm) thick and a Class A armor belt 12.1 inches (307 mm) thick mounted on 0.875-inch (22.2 mm) STS backing plate; the armor belt is sloped at 19 degrees, equivalent to 17.3 in (439 mm) of vertical class B armor at 19,000 yards.
The first Iowa-class ship was laid down in June 1940; in their World War II configuration, each of the Iowa-class battleships had a main battery of 16-inch (406 mm) guns that could hit targets nearly 20 statute miles (32 km) away with a variety of artillery shells designed for anti-ship or bombardment work. The secondary battery of 5-inch (127 ...
Each D839 propellant (smokeless powder) grain used for full charges for this gun was 2 in (51 mm) long, 1 in (25 mm) in diameter and had seven perforations, each 0.060 in (1.5 mm) in diameter with a web thickness range of 0.193 to 0.197 in (4.9 to 5.0 mm) between the perforations and the grain diameter. A maximum charge consisted of six silk ...
USS Iowa (BB-61) is a retired battleship, the lead ship of her class, and the fourth in the United States Navy to be named after the state of Iowa.Owing to the cancellation of the Montana-class battleships, Iowa is the last lead ship of any class of United States battleships and was the only ship of her class to serve in the Atlantic Ocean during World War II.
Thicknesses of belt armor ranged from 10 inches (25 cm) for Strasbourg class - large battlecruisers rather than pure battleships - or from 12 inches (30 cm) for the South Dakota and Iowa classes to 16 inches (41 cm) for the Yamato class. [28] [29]
Traditionally, a warship's armor system was designed both separately from, and after, the design layout. The design and location of various component subsystems (propulsion, steering, fuel storage and management, communications, range-finding, etc.) were laid out and designed in a manner that presented the most efficient and economical utilization of the hull's displacement.
USS Iowa was a pre-dreadnought battleship built for the United States Navy in the mid-1890s. The ship was a marked improvement over the previous Indiana -class battleships , correcting many of the defects in the design of those vessels.
USS Missouri of the Iowa class, ... Total armor thickness on the centerline would therefore have been 9.925 in (252 mm) over the citadel and 10.3 in (262 mm) thick ...