Search results
Results From The WOW.Com Content Network
A clamper will bind the upper or lower extreme of a waveform to a fixed DC voltage level. These circuits are also known as DC voltage restorers. Clampers can be constructed in both positive and negative polarities. When unbiased, clamping circuits will fix the voltage lower limit (or upper limit, in the case of negative clampers) to 0 volts.
A clamper circuit is not a clipper, but the simple diode version has a similar topology to a clipper with the exception that the resistor is replaced with a capacitor. The clamper circuit fixes either the positive or negative peaks at a fixed voltage (determined by the biasing voltage) rather than clipping them off.
They should be V in +V bias-V D for the positive clamper and -V in-V bias +V D for the negative clamper. I verified the equations with PSpice. The equations used is this article are completely off. I don't understand where the 2 multiplier comes from. Likewise, the equations for the unbiased circuits has the same problem.
Grid leak bias: When the grid is driven positive during part of the input frequency cycle, such as in class C operation, rectification in the grid circuit in conjunction with capacitive coupling of the input signal to the grid produces negative DC voltage at the grid.
The standard two-diode Baker clamp circuit, which includes the feedback current I 1 that reduces the base current I b Baker clamp alternative in a Schottky transistor. The Baker clamp is named after Richard H. Baker, who described it in his 1956 technical report "Maximum Efficiency Transistor Switching Circuits". [2]
A clamper can mean: A clamper, an electronic circuit. A spiked plate worn on the sole of the shoe to prevent slipping when walking on ice. A person who applies a wheel clamp to a vehicle parked illegally or on private land. A person who belongs to the Ancient and Honorable Society of E Clampus Vitus. A character in Trolls World Tour
A load line diagram, illustrating an operating point in the transistor's active region.. Biasing is the setting of the DC operating point of an electronic component. For bipolar junction transistors (BJTs), the operating point is defined as the steady-state DC collector-emitter voltage and the collector current with no input signal applied.
The voltage v and current i variables in an electrical component must be defined according to the passive sign convention; positive conventional current is defined to enter the positive voltage terminal; this means power P flowing from the circuit into the component is defined to be positive, while power flowing from the component into the circuit is negative.