Search results
Results From The WOW.Com Content Network
Therefore, an antibiotic with PAE would require less frequent administration and it could improve patient adherence with regard to pharmacotherapy. [ 3 ] [ 5 ] Proposed mechanisms include (1) slow recovery after reversible nonlethal damage to cell structures; (2) persistence of the drug at a binding site or within the periplasmic space ; and (3 ...
A highly potent drug (e.g., fentanyl, clonazepam, risperidone, benperidol, bumetanide) evokes a given response at low concentrations, while a drug of lower potency (e.g. morphine, alprazolam, ziprasidone, haloperidol, furosemide) evokes the same response only at higher concentrations.
metronidazole – antibiotic against anaerobic bacteria; milbemycin oxime – broad spectrum antiparasitic used as an anthelmintic, insecticide and miticide; mirtazapine – antiemetic and appetite stimulant in cats and dogs; mitratapide – used to help weight loss in dogs; morphine – pure mu agonist/opioid analgesic used as a premedication
The following is a list of antibiotics. The highest division between antibiotics is bactericidal and bacteriostatic. Bactericidals kill bacteria directly, whereas bacteriostatics prevent them from dividing. However, these classifications are based on laboratory behavior.
The use of trapezoidal rule in AUC calculation was known in literature by no later than 1975, in J.G. Wagner's Fundamentals of Clinical Pharmacokinetics. A 1977 article compares the "classical" trapezoidal method to a number of methods that take into account the typical shape of the concentration plot, caused by first-order kinetics. [8]
Acute use (1–3 days) yields a potency about 1.5× stronger than that of morphine and chronic use (7 days+) yields a potency about 2.5 to 5× that of morphine. Similarly, the effect of tramadol increases after consecutive dosing due to the accumulation of its active metabolite and an increase of the oral bioavailability in chronic use.
Half maximal inhibitory concentration (IC 50) is a measure of the potency of a substance in inhibiting a specific biological or biochemical function. IC 50 is a quantitative measure that indicates how much of a particular inhibitory substance (e.g. drug) is needed to inhibit, in vitro, a given biological process or biological component by 50%. [1]
It is commonly used as a measure of a drug's potency, although the use of EC 50 is preferred over that of 'potency', which has been criticised for its vagueness. [3] EC 50 is a measure of concentration, expressed in molar units (M), where 1 M is equivalent to 1 mol / L .