Search results
Results From The WOW.Com Content Network
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
English: A 1964/1965 Chrysler B 383 V8 engine undergoing some work at Autosports Designs in Huntington, NY (Long Island). These are so plentiful that they used to be considered throwaways...
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
Jensen Motors used Chrysler V8 engines for the Interceptor, starting with the 6,276 cc (383 c.i.) with optional manual (Mark I, 22 built) or TorqueFlite automatic transmissions driving the rear wheels through a limited slip differential in a conventional Salisbury rear axle. In 1970, the 383 c.i. produced 335 hp SAE gross, or 270 hp SAE net.
Chrysler used a 14 mm (0.55 in) spark plug, rather than the typical 18 mm (0.71 in), in an effort to fit it as centrally as possible in the combustion chamber. [ 1 ] The intake and exhaust valves were the same size as the 426's, [ 6 ] the 2.25 in (57 mm) intake canted at 15° from the bore centerline, the 1.94 in (49 mm) exhaust at 6°. [ 6 ]
For 1970 and 1971, the Barracuda and Barracuda Gran Coupe had two slant I6 engines available — a new 198 cu in (3.2 L) version and the previous 225 — as well as four V8 options: the 318 CID, the 383 with a two-barrel carburetor and single exhaust, the 383 cu in (6.3 L) with a four-barrel and dual exhausts, and the 383 Magnum with a four ...
The Polyspheric engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to its Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads , pushrods, exhaust manifolds and pistons.
The Chrysler flathead engine is a flathead inline automotive engine manufactured by the Chrysler Corporation from 1924 through the early 1960s. It came in four-,six-, and eight-cylinder configurations and varying displacements, with both cast iron and cast aluminum cylinder heads. It was installed in Chrysler, DeSoto, Dodge, and Plymouth ...