Search results
Results From The WOW.Com Content Network
The 1960 383 engines featured the same basic ram induction system as the Chrysler 300F's 413 RB engines (named Sonoramic Commando when sold in Plymouth form). The later 383 Magnum (starting in 1968) used the 440 Magnum heads, camshaft, and exhaust manifolds. This engine was advertised at 335 hp (250 kW; 340 PS).
English: A 1964/1965 Chrysler B 383 V8 engine undergoing some work at Autosports Designs in Huntington, NY (Long Island). These are so plentiful that they used to be considered throwaways...
It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5] It was one of the last carbureted car/truck engines built in North America. [6] Chrysler never used this engine in any other vehicle.
For 1970 and 1971, the Barracuda and Barracuda Gran Coupe had two slant I6 engines available — a new 198 cu in (3.2 L) version and the previous 225 — as well as four V8 options: the 318 CID, the 383 with a two-barrel carburetor and single exhaust, the 383 cu in (6.3 L) with a four-barrel and dual exhausts, and the 383 Magnum with a four ...
Jensen Motors used Chrysler V8 engines for the Interceptor, starting with the 6,276 cc (383 c.i.) with optional manual (Mark I, 22 built) or TorqueFlite automatic transmissions driving the rear wheels through a limited slip differential in a conventional Salisbury rear axle. In 1970, the 383 c.i. produced 335 hp SAE gross, or 270 hp SAE net.
Chrysler used a 14 mm (0.55 in) spark plug, rather than the typical 18 mm (0.71 in), in an effort to fit it as centrally as possible in the combustion chamber. [ 1 ] The intake and exhaust valves were the same size as the 426's, [ 6 ] the 2.25 in (57 mm) intake canted at 15° from the bore centerline, the 1.94 in (49 mm) exhaust at 6°. [ 6 ]
The Polyspheric engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to its Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads , pushrods, exhaust manifolds and pistons.
The Chrysler flathead engine is a flathead inline automotive engine manufactured by the Chrysler Corporation from 1924 through the early 1960s. It came in four-,six-, and eight-cylinder configurations and varying displacements, with both cast iron and cast aluminum cylinder heads. It was installed in Chrysler, DeSoto, Dodge, and Plymouth ...