Search results
Results From The WOW.Com Content Network
A cooling curve of naphthalene from liquid to solid. A cooling curve is a line graph that represents the change of phase of matter, typically from a gas to a solid or a liquid to a solid. The independent variable (X-axis) is time and the dependent variable (Y-axis) is temperature. [1] Below is an example of a cooling curve used in castings.
In context of Mpemba effect it is a mistake to think that bottom ice insulates, compared to poor air cooling properties. [ 25 ] Dissolved gases : Cold water can contain more dissolved gases than hot water, which may somehow change the properties of the water with respect to convection currents, a proposition that has some experimental support ...
However, greater undercooling by rapid quenching results in formation of martensite or bainite instead of pearlite. This is possible provided the cooling rate is such that the cooling curve intersects the martensite start temperature or the bainite start curve before intersecting the P s curve. The martensite transformation being a ...
A phase diagram in physical chemistry, engineering, mineralogy, and materials science is a type of chart used to show conditions (pressure, temperature, etc.) at which thermodynamically distinct phases (such as solid, liquid or gaseous states) occur and coexist at equilibrium.
The gas-cooling throttling process is commonly exploited in refrigeration processes such as liquefiers in air separation industrial process. [7] [8] In hydraulics, the warming effect from Joule–Thomson throttling can be used to find internally leaking valves as these will produce heat which can be detected by thermocouple or thermal-imaging ...
The upper curve is the line of liquidus, and the lower curve is the line of solidus. In chemistry, materials science, and physics, the liquidus temperature specifies the temperature above which a material is completely liquid, [2] and the maximum temperature at which crystals can co-exist with the melt in thermodynamic equilibrium.
Thus, the liquid–liquid critical point in a two-component system must satisfy two conditions: the condition of the spinodal curve (the second derivative of the free energy with respect to concentration must equal zero), and the extremum condition (the third derivative of the free energy with respect to concentration must also equal zero or ...
There are two types of continuous cooling diagrams drawn for practical purposes. Type 1: This is the plot beginning with the transformation start point, cooling with a specific transformation fraction and ending with a transformation finish temperature for all products against transformation time for each cooling curve.