Search results
Results From The WOW.Com Content Network
The New Madrid seismic zone (NMSZ), sometimes called the New Madrid fault line (or fault zone or fault system), is a major seismic zone and a prolific source of intraplate earthquakes (earthquakes within a tectonic plate) in the Southern and Midwestern United States, stretching to the southwest from New Madrid, Missouri.
Map depicting the extent of the Ramapo Fault System in New York, New Jersey, and Pennsylvania. The Ramapo Fault zone is a system of faults between the northern Appalachian Mountains and Piedmont areas to the east. [1]
This list covers all faults and fault-systems that are either geologically important [clarification needed] or connected to prominent seismic activity. [clarification needed] It is not intended to list every notable fault, but only major fault zones.
Locations of quakes magnitude 2.5 or greater in the Wabash Valley (upper right) and New Madrid (lower left) Seismic Zones. The Wabash Valley seismic zone (also known as the Wabash Valley fault system or fault zone) is a tectonic region located in the Midwestern United States, centered on the valley of the lower Wabash River, along the state line between southeastern Illinois and southwestern ...
The San Jacinto Fault Zone and the San Andreas Fault (SAF) accommodate up to 80% of the slip rate between the North American and Pacific plates.The extreme southern portion of the SAF has experienced two moderate events in historical times, while the SJFZ is one of California's most active fault zones and has repeatedly produced both moderate and large events.
Seismic faults of Washington (state) (4 P) Pages in category "Seismic faults of the United States" The following 20 pages are in this category, out of 20 total.
What are the fault lines under New York and New Jersey? Fault lines are fractures between blocks of rock in the Earth’s crust, the layer closest to the surface. These lines allow tectonic plates ...
The first statewide geologic map of Georgia was published in 1825. It was a 1:1,000,000 scale map of Georgia and Alabama published by Henry Schenck Tanner. [3] In 1849 W.T. Williams published the geological features for the state on a 1:120,000 scale map within George White's (1849) Statistics of the State of Georgia report. [4]