Ads
related to: how to solder header pins video cable ends assembly tool
Search results
Results From The WOW.Com Content Network
Dip soldering is a small-scale soldering process by which electronic components are soldered to a printed circuit board (PCB) to form an electronic assembly. The solder wets to the exposed metallic areas of the board (those not protected with solder mask ), creating a mechanical and electrical connection.
1×6 pin header (one row) 1×6 female header (one row) A pin header (or simply, header) is a form of electrical connector. A male pin header consists of one or more rows of metal pins molded into a plastic base, often 2.54 mm (0.1 in) apart, though available in many spacings. [1] Male pin headers are cost-effective due to their simplicity.
1 Mini-DIN 4-pin, 1 Mini-DIN 7-pin, 1 Mini-VGA, 2 BNC, 2 RCA connectors, 8-pin DIN, [4] SCART 21-pin: S-VHS, some laptop computers, analog broadcast video, 1980-1990s home computers including the Commodore 64, C128 and Atari 8-bit computers: The 4-pin mini-DIN that is most common in consumer products today debuted in JVC's 1987 S-VHS. The 7-pin ...
Pogo pin connectors. Pogo pin or spring loaded connectors are commonly used in consumer and industrial products, where mechanical resilience and ease of use are priorities. [32] The connector consists of a barrel, a spring, and a plunger. They are in applications such as the MagSafe connector where a quick disconnect is desired for safety.
Selective soldering is the process of selectively soldering components to printed circuit boards and molded modules that could be damaged by the heat of a reflow oven or wave soldering in a traditional surface-mount technology (SMT) or through-hole technology assembly processes. This usually follows an SMT oven reflow process; parts to be ...
In high-powered applications, the die is usually eutectic bonded onto the package, using e.g. gold-tin or gold-silicon solder (for good heat conduction). For low-cost, low-powered applications, the die is often glued directly onto a substrate (such as a printed wiring board) using an epoxy adhesive. Alternatively dies can be attached using solder.
Mechanical wire wrap tool Electrical wire wrap tool; pneumatic (air-powered) tools are also available. A "wire wrap tool" has two holes. The wire and 1 ⁄ 4 in (6.4 mm) of insulated wire are placed in a hole near the edge of the tool. The hole in the center of the tool is placed over the post. The tool is rapidly twisted.
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.