Ad
related to: winbridge voice amplifier wb001 how to use youtube for beginners guide tutorial
Search results
Results From The WOW.Com Content Network
The amplifier damping factor, which is the ratio of the nominal load impedance (driver voice coil) to amplifier output impedance, is adequate in either case for well-designed solid state amplifiers. Tube amplifiers have sufficiently higher output impedances that they normally included multi-tap output transformers to better match to the driver ...
Audio stereo power amplifier made by McIntosh The internal view of a Mission Cyrus One hi-fi integrated audio amplifier (1984) [1]. An audio power amplifier (or power amp) amplifies low-power electronic audio signals, such as the signal from a radio receiver or an electric guitar pickup, to a level that is high enough for driving loudspeakers or headphones.
Sound reinforcement in a large format system typically involves a signal path that starts with the signal inputs, which may be instrument pickups (on an electric guitar or electric bass) or a microphone that a vocalist is singing into or a microphone placed in front of an instrument or guitar amplifier.
Most of the amplifiers produced by ACC were solid-state, but a few models later in production were valve amps. The company is remembered in particular for its Acoustic 361 bass stack, consisting of an Acoustic 360 bass pre-amplifier and one or two Acoustic 361 W-bins, each featuring a built-in 200-watt RMS power amplifier and a rear-facing 18" Cerwin-Vega loudspeaker.
Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts.The electrical power delivered to the loudspeaker, together with its efficiency, determines the sound power generated (with the rest of the electrical power being converted to heat).
Loudspeaker with attached step-down transformer for use on a constant-voltage system. Constant-voltage speaker systems refer to networks of loudspeakers which are connected to an audio amplifier using step-up and step-down transformers to simplify impedance calculations and to minimize power loss over the speaker cables.
Another type of normalization is based on a measure of loudness, wherein the gain is changed to bring the average loudness to a target level. This average may be approximate, such as a simple measurement of average power (e.g. RMS), or more accurate, such as a measure that addresses human perception e.g. that defined by EBU R128 and offered by ReplayGain, Sound Check and GoldWave.
The LA-2A was invented by James F. Lawrence II, founder of the Teletronix Engineering Company in Pasadena, California in the early 1960s. The LA-2A had evolved from Lawrence's first leveling amplifier, the LA-1, which was favored by Gene Autry, and its successor, the LA-2, which had been adopted by CBS and RCA.