Search results
Results From The WOW.Com Content Network
In science and engineering, the parts-per notation is a set of pseudo-units to describe small values of miscellaneous dimensionless quantities, e.g. mole fraction or mass fraction. Since these fractions are quantity-per-quantity measures, they are pure numbers with no associated units of measurement. Commonly used are parts-per-million (ppm, 10 ...
Non-road diesel engine fuel moved to 500 ppm sulfur in 2007, and further to ULSD in 2010. Railroad locomotive and marine diesel fuel moved to 500 ppm sulfur in 2007, and changed to ULSD in 2012. There were exemptions for small refiners of non-road, locomotive and marine diesel fuel that allowed for 500 ppm diesel to remain in the system until 2014.
EN 590. EN 590 is a standard published by the European Committee for Standardization that describes the physical and chemical properties that all automotive diesel fuel must meet if it is to be sold in the European Union and several other European countries. Based on 98/70/EG it allows the blending of up to 7% fatty acid methyl ester biodiesel ...
In the 1990s specifications allowed a content of 2000 ppm max of sulfur, reduced to a limit of 350 ppm by the beginning of the 21st century with the introduction of Euro 3 specifications. The limit was lowered with the introduction of Euro 4 by 2006 to 50 ppm (ULSD, Ultra Low Sulfur Diesel). The standard for diesel fuel in force in Europe as of ...
Diisopropyl ether is a secondary ether that is used as a solvent. It is a colorless liquid that is slightly soluble in water, but miscible with organic solvents. It is used as an extractant and an oxygenate gasoline additive. It is obtained industrially as a byproduct in the production of isopropanol by hydration of propylene. [3]
Solvent Yellow 124 is a yellow azo dye used in European Union as a fuel dye. It is a marker used since August 2002 to distinguish diesel fuel intended for heating from a higher- taxed motor diesel fuel. It is added to fuels not intended for motor vehicles in amounts of 6 mg/L or 7 mg/kg under the name Euromarker. [1]
Chemical oxygen demand. In environmental chemistry, the chemical oxygen demand (COD) is an indicative measure of the amount of oxygen that can be consumed by reactions in a measured solution. It is commonly expressed in mass of oxygen consumed over volume of solution, which in SI units is milligrams per liter (mg / L).
The peroxide value is defined as the amount of peroxide oxygen per 1 kilogram of fat or oil. Traditionally this was expressed in units of milliequivalents, although in SI units the appropriate option would be in millimoles per kilogram (N.B. 1 milliequivalents = 0.5 millimole; because 1 mEq of O2 =1 mmol/2=0.5 mmol of O2, where 2 is valence).