Search results
Results From The WOW.Com Content Network
Benzamide is an organic compound with the chemical formula of C 7 H 7 NO. It is the simplest amide derivative of benzoic acid. In powdered form, it appears as a white solid, while in crystalline form, it appears as colourless crystals. [5] It is slightly soluble in water, [2] and soluble in many organic solvents. [6]
Pauling's second rule is that the value of the first pK a for acids of the formula XO m (OH) n depends primarily on the number of oxo groups m, and is approximately independent of the number of hydroxy groups n, and also of the central atom X. Approximate values of pK a are 8 for m = 0, 2 for m = 1, −3 for m = 2 and < −10 for m = 3. [28]
the ionization of substituted phenols in water (+2.008) the acid catalyzed esterification of substituted benzoic esters in ethanol (-0.085) the acid catalyzed bromination of substituted acetophenones (Ketone halogenation) in an acetic acid/water/hydrochloric acid (+0.417) the hydrolysis of substituted benzyl chlorides in acetone-water at 69.8 ...
Note that the especially high molar values, as for paraffin, gasoline, water and ammonia, result from calculating specific heats in terms of moles of molecules. If specific heat is expressed per mole of atoms for these substances, none of the constant-volume values exceed, to any large extent, the theoretical Dulong–Petit limit of 25 J⋅mol ...
The values for the octanol-water system in the following table are from the Dortmund Data Bank. [ 15 ] [ better source needed ] They are sorted by the partition coefficient, smallest to largest (acetamide being hydrophilic, and 2,2',4,4',5-pentachlorobiphenyl lipophilic), and are presented with the temperature at which they were measured (which ...
Benzoic acid is cheap and readily available, so the laboratory synthesis of benzoic acid is mainly practiced for its pedagogical value. It is a common undergraduate preparation. Benzoic acid can be purified by recrystallization from water because of its high solubility in hot water and poor solubility in cold water. The avoidance of organic ...
The K factor or characterization factor is defined from Rankine boiling temperature °R=1.8Tb[k] and relative to water density ρ at 60°F: . K(UOP) = / The K factor is a systematic way of classifying a crude oil according to its paraffinic, naphthenic, intermediate or aromatic nature. 12.5 or higher indicate a crude oil of predominantly paraffinic constituents, while 10 or lower indicate a ...
Although the maximum rate of biotransformation of benzoic acid to hippuric acid varied between 17.2 and 28.8 mg.kg-1.h-1 among the six individuals, the mean value (23.0 mg.kg-1.h-1) was fairly close to that provided by daily maximum dose (0.5 g.kg-1.day-1) recommended in the treatment of hyperammonaemia in patients with inborn errors of ureagenesis