Search results
Results From The WOW.Com Content Network
Basic aircraft control surfaces and motion. A)aileron B)control stick C)elevator D)rudder. Aircraft flight control surfaces are aerodynamic devices allowing a pilot to adjust and control the aircraft's flight attitude. Development of an effective set of flight control surfaces was a critical advance in the development of aircraft.
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
The design of the rudder travel limiter on the Airbus A300-600 was cited as a contributing factor to the crash of American Airlines Flight 587. In addition to a low rudder pedal sensitivity compared to other aircraft, the A300-600 had a variable stop design, contrary to earlier iterations of the A300, which used a variable ratio design. [4]
A rudder pedal is a foot-operated aircraft flight control interface for controlling the rudder of an aircraft. [1] [2] The usual set-up in modern aircraft is that each pilot has a pedal set consisting of a pair of pedals, with one pedal for each foot. Each right and left pedal works together so that one pedal pops out when the other is ...
A yaw damper may remove the necessity for a pilot to make any contact with the rudder pedals during turns on a range of aircraft, including jet-powered ones. [2] [3] Some aircraft, such as the Boeing 727 and Vickers VC10 airliners, are fitted with multiple yaw damper systems due to their operation having been deemed critical to flight safety ...
The National Transportation Safety Board on Thursday issued urgent safety recommendations about the potential for a jammed rudder control system on some Boeing 737 airplanes after a February ...
During the 1990s, a series of issues affecting the rudder of Boeing 737 passenger aircraft resulted in multiple incidents. In two separate accidents (United Airlines Flight 585 and USAir Flight 427), pilots lost control of their aircraft due to a sudden and unexpected rudder movement, and the resulting crashes killed everyone on board, 157 people in total. [1]
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.