When.com Web Search

  1. Ad

    related to: engine shaking and loss of power when starting a work environment

Search results

  1. Results From The WOW.Com Content Network
  2. Low-speed pre-ignition - Wikipedia

    en.wikipedia.org/wiki/Low-Speed_Pre-Ignition

    Engine management systems can overcome pre ignition by the means of a knock or detonation sensor. The sensor will detect pre ignition and retard the engines timing to protect the engine from damage. Undesired engine behavior will occur such as loss of performance or power.

  3. Engine balance - Wikipedia

    en.wikipedia.org/wiki/Engine_balance

    Engine balance refers to how the inertial forces produced by moving parts in an internal combustion engine or steam engine are neutralised with counterweights and balance shafts, to prevent unpleasant and potentially damaging vibration. The strongest inertial forces occur at crankshaft speed (first-order forces) and balance is mandatory, while ...

  4. Balance shaft - Wikipedia

    en.wikipedia.org/wiki/Balance_shaft

    This engine was the first to locate one balance shaft higher than the other, to counteract the second order rolling couple (i.e. about the crankshaft axis) due to the torque exerted by the inertia caused by increases and decreases in engine speed. [6] [7] In a flat-four engine, the forces are cancelled out by the pistons moving in opposite ...

  5. Engine efficiency - Wikipedia

    en.wikipedia.org/wiki/Engine_efficiency

    The efficiency of internal combustion engines depends on several factors, the most important of which is the expansion ratio. For any heat engine the work which can be extracted from it is proportional to the difference between the starting pressure and the ending pressure during the expansion phase. Hence, increasing the starting pressure is ...

  6. Dieseling - Wikipedia

    en.wikipedia.org/wiki/Dieseling

    Dieseling or engine run-on is a condition that can occur in spark-plug-ignited, gasoline-powered internal combustion engines, whereby the engine keeps running for a short period after being turned off, drawing fuel through the carburetor, into the engine and igniting it without a spark.

  7. Mean effective pressure - Wikipedia

    en.wikipedia.org/wiki/Mean_effective_pressure

    The mean effective pressure (MEP) is a quantity relating to the operation of a reciprocating engine and is a measure of an engine's capacity to do work that is independent of engine displacement. [1] Despite having the dimension of pressure, MEP cannot be measured. [ 2 ]

  8. 63,000 Jeeps recalled over potential loss of power and ... - AOL

    www.aol.com/63-000-jeeps-recalled-over-202735099...

    Stellantis warns that a poorly fitted part in some Jeep Cherokees could cause the vehicles to lose power, increasing the risk of crash. 63,000 Jeeps recalled over potential loss of power and ...

  9. Internal combustion engine - Wikipedia

    en.wikipedia.org/wiki/Internal_combustion_engine

    The battery's charged state is maintained by an automotive alternator or (previously) a generator which uses engine power to create electrical energy storage. The battery supplies electrical power for starting when the engine has a starting motor system, and supplies electrical power when the engine is off. The battery also supplies electrical ...