Search results
Results From The WOW.Com Content Network
The 1929 Worthington Model A golf tractor was fitted with a Model A engine, [6] [48] as was the scarce PAL Tractor. [49] Thieman Harvester Company / Thieman Brothers, in 1936, began offering tractors – either complete with Ford Model A engine (about $500), or as a kit, without engine, driveshaft, or rear end ($185).
With over 290,000 sold by the end of its original production in 1952, it was a popular tractor that used Deere & Company's two cylinder design. [2] [3] [4] Early tractors burnt distillate, a petroleum byproduct similar to kerosene, [5] which became a selling point owing to the fuel's low price. Deere & Company's two cylinder design strung from ...
This engine provided 40 hp (30 kW; 41 PS). [12] Top speed was around 65 mph (105 km/h). The Model A had a 103.5 in (2,630 mm) wheelbase with a final drive ratio of 3.77:1. The transmission was a conventional unsynchronized three-speed sliding-gear manual [12] with a single speed reverse. The Model A had four-wheel mechanical drum brakes. [12]
The 730 was a 59 hp (44 kW) tractor at the belt and 54 hp (40 kW) at the drawbar. After making more than 1 + 1 ⁄ 4 million two-cylinder tractors, Deere & Company switched to four- and six-cylinder engines. Announcement of the change came after seven years of development, and forty million dollars in retooling.
Allis-Chalmers Model E (1918–1936): Also known as Model 15-30, 18-30, 20-35, 25-40, 30-60 (The 30-60 is a rare variation of the 25-40 also known as the "Thresherman's Special") Allis-Chalmers Model ED40 (1964):200 imported from Allis-Chalmers International ( United Kingdom Essendine factory ) through Canadian dealerships.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
List of tractor models by manufacturer at tractordata.com This page was last edited on 14 December 2024, at 20:14 (UTC). Text is available under the Creative ...
As with other Farmall letter-series tractors, the design featured an integral frame and unitary construction, allowing entire assemblies to be replaced. Rear wheels on all models used a geared portal axle to provide sufficient ground clearance, and could be adjusted in width over a range of 40 inches (100 cm) to 68 inches (170 cm). [5] [6]