Search results
Results From The WOW.Com Content Network
An mSATA SSD on top of a 2.5-inch SATA drive. Serial ATA (SATA). The SATA data cable has one data pair for differential transmission of data to the device, and one pair for differential receiving from the device, just like EIA-422. That requires that data be transmitted serially.
A 3.5-inch Serial ATA hard disk drive A 2.5-inch Serial ATA solid-state drive. SATA was announced in 2000 [4] [5] in order to provide several advantages over the earlier PATA interface such as reduced cable size and cost (seven conductors instead of 40 or 80), native hot swapping, faster data transfer through higher signaling rates, and more efficient transfer through an (optional) I/O queuing ...
Hence, its protocol is usually ATA (a.k.a. PATA), SATA, SCSI, FC or SAS. The front-end interface communicates with a computer's host adapter (HBA, Host Bus Adapter) and uses: one of ATA, SATA, SCSI, FC; these are popular protocols used by disks, so by using one of them a controller may transparently emulate a disk for a computer.
Inner view of a 1998 Seagate HDD that used the Parallel ATA interface 2.5-inch SATA drive on top of 3.5-inch SATA drive, showing close-up of (7-pin) data and (15-pin) power connectors. Current hard drives connect to a computer over one of several bus types, including parallel ATA, Serial ATA, SCSI, Serial Attached SCSI (SAS), and Fibre Channel.
The interface is primarily used to connect a video source to a display device such as a computer monitor, though it can also be used to transmit audio, USB, and other forms of data. Unline HDMI, DisplayPort is open source. drive bay A standard-sized area within a computer case for adding hardware (hard drives, CD drives, etc.) to a computer.
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]
Mass storage interfaces such as SATA, M.2, and historical PATA. This typically allows attachment of hard drives or SSDs. Real-time clock. Programmable interval timer. High Precision Event Timer. ACPI controller or APM controller. SPI serial bus mostly used for firmware (e.g., BIOS/UEFI) flash storage access. Nonvolatile BIOS memory.
ATA-2 also was the first to note that devices other than hard drives could be attached to the interface: 3.1.7 Device: Device is a storage peripheral. Traditionally, a device on the ATA interface has been a hard disk drive, but any form of storage device may be placed on the ATA interface provided it adheres to this standard.