Search results
Results From The WOW.Com Content Network
In electrical engineering, characteristics like current or voltage can be measured by an ammeter, a voltmeter, a multimeter, etc. The ammeter is used in series with the load, so the same current flows through the load and the ammeter.
Cutaway diagram of a shielded multicore cable with four cores each with three individual conductors. A multicore cable is a type of electrical cable that combines multiple signals or power feeds into a single jacketed cable. [1] The term is normally only used in relation to a cable that has more cores than commonly encountered. [2]
In North America, overhead distribution systems may be three phase, four wire, with a neutral conductor. Rural distribution system may have long runs of one phase conductor and a neutral. [17] In other countries or in extreme rural areas the neutral wire is connected to the ground to use that as a return (single-wire earth return).
power engineering That part of electrical engineering that deals with the generation, distribution and consumption of electrical power. power-factor correction Apparatus intended to bring the power factor of some load closer to 1. power factor The ratio of apparent power flowing to a load divided by the real power. power-flow study
where is the length of the conductor, measured in metres [m], A is the cross-section area of the conductor measured in square metres [m 2], σ is the electrical conductivity measured in siemens per meter (S·m −1), and ρ is the electrical resistivity (also called specific electrical resistance) of the material, measured in ohm-metres (Ω·m ...
One voltage cycle of a three-phase system. A polyphase system (the term coined by Silvanus Thompson) is a means of distributing alternating-current (AC) electrical power that utilizes more than one AC phase, which refers to the phase offset value (in degrees) between AC in multiple conducting wires; phases may also refer to the corresponding terminals and conductors, as in color codes.
Conductor sizes range from 12 mm 2 (#6 American wire gauge) to 1,092 mm 2 (2,156,000 circular mils area), with varying resistance and current-carrying capacity. For large conductors (more than a few centimetres in diameter), much of the current flow is concentrated near the surface due to the skin effect. The center of the conductor carries ...
This makes no difference to the theoretical behaviour of the circuit, so analysis carried out on it is still valid. It would, however, make a practical difference if a circuit were to be implemented this way in that it would destroy the isolation between the parts. An example would be a transformer earthed on both the primary and secondary side.