Search results
Results From The WOW.Com Content Network
These trays may be made of wire mesh, called "cable basket", [2] or be designed in the form of a single central spine (rail) with ribs to support the cable on either side. Channel Tray provides an economical support for cable drops and branch cable runs from the backbone cable tray system. Channel cable tray is used for installations with ...
The most common types that are added to fiber optic cable in inside plant environments are LC, SC, ST, and FC. Some fiber connectors are pre-polished mechanical connectors for ease of installation or anaerobic connectors which require cleaving and polishing. [1] Once the appropriate connector has been identified, the termination process can begin.
The IT industry needs data cables to be added, moved, or removed many times during the life of the installation. It is usual practice to install "fixed cables" between cabling closets or cabinets. These cables are contained in cable trays etc., and are terminated at each end onto patch panels in
ANSI/TIA-568.3-D addresses components of fiber optic cable systems, and ANSI/TIA-568-C.4, addressed coaxial cabling components. [ 6 ] The intent of these standards is to provide recommended practices for the design and installation of cabling systems that will support a wide variety of existing and future services.
An alternative to OPGW is use of the power cables to support a separately-installed fiber bundle. Other alternatives include fiber-bearing composite power conductors (OPCC), wrapped fibre optic cable (SkyWrap or OPAC), or using transmission towers to support a separate All-Dielectric Self-Supporting fiber cable with no conductive elements.
Fiber cables are generally supported on the lower cross-arms of the tower, which provides good clearance to the ground. When the fibers are installed in the middle of a tower, the fiber cable is unlikely to hit energized conductors. Lower weights and forces are used for installation, compared with metallic cables, so lighter equipment can be used.
A fiber management system (FMS) manages optical fiber connections from outside of fiber rack to the fiber routers. Fiber-optic cable duct containing many fibers comes from far end sites and terminates on the FMS using splicing technology. FMS has fiber in and fiber out ports. From fiber out port the fiber patch will go to fiber optics based router.
A common cable installation technique for fiber cables remains cable pulling. After the duct is placed, a high-strength pull line is blown into the duct (if one has not already been pre-installed by the duct manufacturer). The pull line is attached to one end of the cable and is used to pull the cable through the duct.