Search results
Results From The WOW.Com Content Network
A potentiometric surface is the imaginary plane where a given reservoir of fluid will "equalize out to" if allowed to flow. A potentiometric surface is based on hydraulic principles. For example, two connected storage tanks with one full and one empty will gradually fill/drain to the same level. This is because of atmospheric pressure and gravity.
In fact, since the potentiometric measurement is a non-destructive measurement, assuming that the electrode is in equilibrium with the solution, we are measuring the solution's potential. Potentiometry usually uses indicator electrodes made selectively sensitive to the ion of interest, such as fluoride in fluoride selective electrodes , so that ...
Aquifer testing is a common tool that hydrogeologists use to characterize a system of aquifers, aquitards and flow system boundaries. A slug test is a variation on the typical aquifer test where an instantaneous change (increase or decrease) is made, and the effects are observed in the same well.
Typical aquifer cross-section. An unambiguous definition of "groundwater model" is difficult to give, but there are many common characteristics. A groundwater model may be a scale model or an electric model of a groundwater situation or aquifer. Groundwater models are used to represent the natural groundwater flow in the environment.
In analytical chemistry, potentiometric titration is a technique similar to direct titration of a redox reaction. It is a useful means of characterizing an acid . No indicator is used; instead the electric potential is measured across the analyte , typically an electrolyte solution.
A Limestone aquifer is an aquifer that is made of carbonate minerals namely marine limestone or bioclastic limestone. Fine-grained limestone has low porosity and permeability while bioclastic limestone is the antithesis. As groundwater may dissolve carbonates aquifer forming an extensive dissolution network which is a karst aquifer. [2]
An aquifer may be artificially recharged, such as by pumping reclaimed water from wastewater management projects directly into the aquifer. An example of is the Orange County Water District in California. [6] This organization takes wastewater, treats it to a proper level, and then systematically pumps it back into the aquifers for artificial ...
Aquifer storage and recovery (ASR) is the direct injection of surface water supplies such as potable water, reclaimed water (i.e. rainwater), or river water into an aquifer for later recovery and use. The injection and extraction is often done by means of a well.