When.com Web Search

  1. Ads

    related to: dead end clamp overhead line design

Search results

  1. Results From The WOW.Com Content Network
  2. Stockbridge damper - Wikipedia

    en.wikipedia.org/wiki/Stockbridge_damper

    A Stockbridge damper is a tuned mass damper used to suppress wind-induced vibrations on slender structures such as overhead power lines, [1] long cantilevered signs [2] and cable-stayed bridges. The dumbbell -shaped device consists of two masses at the ends of a short length of cable or flexible rod, which is clamped at its middle to the main ...

  3. Dead-end tower - Wikipedia

    en.wikipedia.org/wiki/Dead-end_tower

    Dead-end towers are also employed at branch points as branch pylons. A tower at which the power line runs further as overhead line and as underground cable is a branch tower for a cable branch. A branch pylon is used to start a line branch. The branch pylon is responsible for holding up both the main line and the start of the branch line.

  4. Overhead line - Wikipedia

    en.wikipedia.org/wiki/Overhead_line

    The generic term used by the International Union of Railways for the technology is overhead line. [1] It is known variously as overhead catenary, overhead contact line (OCL), overhead contact system (OCS), overhead equipment (OHE), overhead line equipment (OLE or OHLE), overhead lines (OHL), overhead wiring (OHW), traction wire, and trolley wire.

  5. Overhead power line - Wikipedia

    en.wikipedia.org/wiki/Overhead_power_line

    In Germany in 1957 the first 380 kV overhead power line was commissioned (between the transformer station and Rommerskirchen). In the same year the overhead line traversing of the Strait of Messina went into service in Italy, whose pylons served the Elbe crossing 1. This was used as the model for the building of the Elbe crossing 2 in the ...

  6. Transmission tower - Wikipedia

    en.wikipedia.org/wiki/Transmission_tower

    Dead-end structures support the full weight of the conductor and also all the tension in it, and also use strain insulators. Structures are classified as tangent suspension, angle suspension, tangent strain, angle strain, tangent dead-end and angle dead-end. [15] Where the conductors are in a straight line, a tangent tower is used.

  7. Pipe support - Wikipedia

    en.wikipedia.org/wiki/Pipe_support

    A pipe support or pipe hanger is a designed element that transfer the load from a pipe to the supporting structures. The load includes the weight of the pipe proper, the content that the pipe carries, all the pipe fittings attached to pipe, and the pipe covering such as insulation.