Ad
related to: 1996 pontiac firebird v6 specs horsepower and speed sensor
Search results
Results From The WOW.Com Content Network
Firebird performance levels improved for 1996, with the establishment of the stronger 200-hp 3.8 L V6 as the new base engine, and the power rating of the LT1 increased to 285 for 1996, due to its new dual catalytic-converter exhaust system. 1996 was also the first model year of the OBD-II computer system. Optional performance enhancements were ...
Introduced in 1981, the 2.8 L (2,837 cc) LH7 was a High Output ("Z-code") version of the LE2 for the higher-performance X-cars like the Chevrolet Citation X-11 and higher-performance A-cars like the Pontiac 6000 STE. It retained a two-barrel carburetor and produced 135 hp (101 kW) and 165 lb⋅ft (224 N⋅m) for 1981 and 145 lb⋅ft (197 N⋅m ...
The third generation Pontiac Firebird was introduced in late 1981 by Pontiac alongside its corporate cousin, the Chevrolet Camaro for the 1982 model year. These were also the first Firebirds with factory fuel injection, four-speed automatic transmissions, five-speed manual transmissions, four-cylinder engines, 16-inch wheels, and hatchback bodies.
Though the pre-3800 rear-wheel drive (RWD) V6 uses the Buick, Oldsmobile, Pontiac (BOP) bellhousing pattern, an oddity of both the front-wheel drive (FWD) and RWD 3800 V6 is that although it is a 90° V6, it uses the GM 60° V6 bell housing (Metric Pattern). For use in the FWD applications, the bellhousings on the FWD transmissions are altered ...
The L98 V8 was optional in January 1987–1992 Chevrolet Camaro and Pontiac Firebird models (rated at 225–245 hp (168–183 kW) and 330–345 lb⋅ft (447–468 N⋅m)) The 1987 versions had 20 hp (15 kW) and 15 lb⋅ft (20 N⋅m) more and a change to hydraulic roller camshaft. Compression was up again in 1990 to 9.5:1 Camaro/Firebird and 10: ...
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations)
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
In 1996, a bolt-on bell housing was phased in (along with a six-bolt tailhousing) for S-10 Trucks and S-10 Blazers and beginning in 1998 for all other applications. Beginning in 1998 a new 300mm torque converter with improved higher-capacity internals, 300mm style input shaft, and 300mm style pump was also introduced on models coupled to a Gen ...