Ads
related to: best heads for 5.3
Search results
Results From The WOW.Com Content Network
An evolution of the 1964 DOHC prototype “XJ13” engine, the Jaguar V12 engine is a family of SOHC internal combustion V12 engines with a common block design, that were mass-produced by Jaguar Cars for a quarter of a century, from 1971 to 1997, mostly as 5.3‑litres, but later also as 6‑litres, and 7‑litre versions that were deployed in racing.
It offers the airflow of more expensive heads, at a much lower cost. It does, however, require a specific intake manifold (the L31 has four bolts per head attaching the intake manifold, as opposed to the "traditional" six bolts per head found on older Chevrolet small-blocks). Chevrolet's L31 was replaced by GM's LS-based 5.3L LM7 and 6.0L LQ4.
The 1966-1967 4-4-2 400 cu in (6.6 L) V8 was a short stroke engine which featured B and C cast large-valve cylinder heads and hydraulic lifters of larger diameter, as well as push-rods of different length and diameter than the standard Olds Rocket V8.
Ford offered a performance head that was a stock part on 1993–1995 Mustang Cobra models and pre-1997 ½ Ford Explorers and Mercury Mountaineers equipped with the 5.0 L engine called the GT-40 head (casting ID F3ZE-AA). In mid-1997, the Explorer and Mountaineer 5.0 L heads were revised and renamed GT40P.
The standard head seen on an L78 400 Pontiac was the low compression 6x8 head, while the 6x4 head seen on the W72 had hardened valve seats for a higher RPM operating range, improved air flow, and higher compression. These heads can be distinguished from 6x8 heads through a small stamped "4" on the top of the front boss.
A 4-barrel carburetor was mated to a high-rise, dual plane intake manifold feeding high-flow cylinder heads that are still considered among the best of that era. [ citation needed ] Its big ports used 2.02 in (51 mm) intake and 1.60 in (41 mm) exhaust valves.