When.com Web Search

  1. Ads

    related to: hdr 400 vs 600 1000 watt amp info rms

Search results

  1. Results From The WOW.Com Content Network
  2. High-dynamic-range television - Wikipedia

    en.wikipedia.org/wiki/High-dynamic-range_television

    For HDR, this number increases to around 1,000–10,000 nits. [1] [5] HDR can represent darker black levels [2] and more saturated colors. [1] The most common SDR formats are limited to the Rec. 709/sRGB gamut, while common HDR formats use Rec. 2100, which is a wide color gamut (WCG). [1] [6] In practice, HDR is not always used at its limits.

  3. Power rating - Wikipedia

    en.wikipedia.org/wiki/Power_rating

    The maximum power measured is the nominal power of the module in Watts. Colloquially, this is also written as "W p"; this format is colloquial as it is outside the standard by adding suffixes to standardized units. The nominal power divided by the light power that falls on the module (area x 1000 W/m 2) is the efficiency.

  4. Root mean square - Wikipedia

    en.wikipedia.org/wiki/Root_mean_square

    The same principle applies, and (for example) a current of 10 amps used for 12 hours each 24-hour day represents an average current of 5 amps, but an RMS current of 7.07 amps, in the long term. The term RMS power is sometimes erroneously used (e.g., in the audio industry) as a synonym for mean power or average power (it is proportional to the ...

  5. Audio power - Wikipedia

    en.wikipedia.org/wiki/Audio_power

    For most audio applications more power is needed at low frequencies. This requires a high-power amplifier for low frequencies (e.g., 200 watts for 20–200 Hz band), lower power amplifier for the midrange (e.g., 50 watts for 200 to 1000 Hz), and even less the high end (e.g. 5 watts for 1000–20000 Hz).

  6. True RMS converter - Wikipedia

    en.wikipedia.org/wiki/True_RMS_converter

    The RMS value of an alternating current is also known as its heating value, as it is a voltage which is equivalent to the direct current value that would be required to get the same heating effect. For example, if 120 V AC RMS is applied to a resistive heating element it would heat up by exactly the same amount as if 120 V DC were applied.

  7. Dynamic range - Wikipedia

    en.wikipedia.org/wiki/Dynamic_range

    The maximum achievable dynamic range for a digital audio system with Q-bit uniform quantization is calculated as the ratio of the largest sine-wave rms to rms noise is: [19] D R A D C = 20 × log 10 ⁡ ( 2 Q 1 ) = ( 6.02 ⋅ Q ) d B {\displaystyle \mathrm {DR_{ADC}} =20\times \log _{10}\left({\frac {2^{Q}}{1}}\right)=\left(6.02\cdot Q\right ...